WaferTransportSolutionManual - 第25页

HEAVY PALLET RAILS PNEUMATIC SCHEMATIC Chapter Issue 1 August 11 Wafer Transport Solutio n 1.17 PNEUMA TIC SCHEMA TIC Snugger Left Snugger Right IN OUT 5/2 16SK10 5/2 16SK03 Flow Controllers Snugger Pilot V alves and Reg…

100%1 / 116
HEAVY PALLET RAILS
ELECTRONIC CONTROL
1.16 Wafer Transport Solution Chapter Issue 1 August 11
ELECTRONIC CONTROL
Controller See the Machine Controller Chapter of the printer manual for further information
on the machine controller.
Nodes 2 and 17 Machine Node 2 provides the motor drive control signals (CAN), whilst the M37
Power Supply provides the drive motor power (see the Electrical Schematic for
details). The heavy pallet stepper motor is Node 17.
CAN Bus In
N2PL2
Snugger and
Belt Drop
Solenoids
N2SK4
CAN Bus Out
N2SK3
Vacuum Tooling
N2SK2
Power
N2PL1
HEAVY PALLET RAILS
PNEUMATIC SCHEMATIC
Chapter Issue 1 August 11 Wafer Transport Solution 1.17
PNEUMATIC SCHEMATIC
Snugger Left
Snugger Right
IN
OUT
5/2
16SK10
5/2
16SK03
Flow Controllers
Snugger Pilot Valves
and Regulators
Rail Lift and Drop Cylinders
Mains Air In
A
B
A
B
HEAVY PALLET RAILS
ADJUSTMENTS & SETTINGS
1.18 Wafer Transport Solution Chapter Issue 1 August 11
ADJUSTMENTS & SETTINGS
NOTE
Before commencing the procedures in this section, ensure that the tooling area
is clear of all tools, and the table surface is clean.
Rising Table Home
Vane
To adjust the rising table home vane, carry out the following:
1. On the machine interface select Maintenance.
2. Select Diagnostics.
3. Select the Rising Table.
4. Select Home Rising Table.
5. Make provision to access the printer on the left hand side.
6. Remove the lower cover from the left side of the printer.
7. Locate the rising table home vane on the rising table left leg.
8. Measure a 122mm gap between the top of the vane and the step on the
underside of the rising table.
9. If adjustment is required, slacken the home vane retaining screws and adjust
the vane.
NOTE
Ensure the vane does not foul the rising table home sensor.
10. Using a combination of the Next and Previous buttons alternately select
Rising Table To Transport Height and Home Rising Table.
11. Observe that the home vane enters the sensor and does not foul. Adjust
the vane as required to prevent this from happening.
12. Insert the Setting Bar (201121) into the ‘C’ Chase.
13. Select Home Rising Table.
View on Underside of Rising Table
122mm
Home Vane
Step