ASM贴片机CPP头半年保养 - 第26页

8 6-monthly CPP Clean / lubricate the DP drive bearing 4 min 2 / 2 CAUTION!Refer to safety instructions in user manual before commencing Mainten- ance NOTICE! ESD guidelines are to be followed Tool: T21, T22, T24 Wear P…

8 6-monthly CPP Clean / lubricate the DP drive bearing 4 min 1 / 2

CAUTION!Refer to safety instructions in user manual before commencing Mainten-

ance

NOTICE! ESD guidelines are to be followed Tool:

T21, T22, T24

Wear Part: Consumables:

C13, C22

1 Prepare the multipette. See appendix

"Prepare the multipette".

2 Turn the wheel and adjust 1 µl. 3 Turn the head upright and put the head

stand flat on the table.

4 Dry clean the drive bearing fixing it with

your finger.

5 Repeat Step 4 for all other segments. 6 Apply 1 x 1 μl to the gap of the bearing

and move it afterwards by 3 turns.

8 6-monthly CPP Clean / lubricate the DP drive bearing 4 min 2 / 2

CAUTION!Refer to safety instructions in user manual before commencing Mainten-

ance

NOTICE! ESD guidelines are to be followed Tool:

T21, T22, T24

Wear Part: Consumables:

C13, C22

7 Repeat step 6 for all other segments. 8 Clean up the multipette. See appendix

"Clean up the mulipette".

9 6-monthly CPP Check / replace the hoses at DP drives 8 min 1 / 3

CAUTION!Refer to safety instructions in user manual before commencing Mainten-

ance

NOTICE! ESD guidelines are to be followed Tool:

T21, T53

Wear Part:

Consumables:

1 Proceed with the head stand flat on the

table.

2 Move the segment out to maximum and

hold it there.

3 Check the vacuum hose for damages.

4 If OK go to step 8. 5 If not OK remove the vacuum hose. 6 Disconnet the hose at the DP drive.