ASM贴片机CPP头半年保养 - 第60页
21 6-monthly CPx+TH Appendix: Maintain the Pressure Regulator Valve (PRV) 10 min 6 / 7 CAUTION!Refer to safety instructions in user manual before commencing Mainten- ance NOTICE! ESD guidelines are to be followed Tool: …
21 6-monthly CPx+TH Appendix: Maintain the Pressure Regulator Valve (PRV) 10 min 5 / 7
CAUTION!Refer to safety instructions in user manual before commencing Mainten-
ance
NOTICE! ESD guidelines are to be followed Tool:
T44, T46, T53, T69, T80
Wear Part:
W28, W42, W45, W46
Consumables:
C3, C5, C11, C19, C22
25 Clean the plunger especially at the tip. 26 Grease the plunger slightly at the raised
positions only and put it back into the
housing.
27 The pin of the plunger must engage in the
notch.
28 Check the plunger is moving easily. 29 If OK proceed with step 31. 30 If not OK remove the plunger and repeat
step 16 to 28.
21 6-monthly CPx+TH Appendix: Maintain the Pressure Regulator Valve (PRV) 10 min 6 / 7
CAUTION!Refer to safety instructions in user manual before commencing Mainten-
ance
NOTICE! ESD guidelines are to be followed Tool:
T44, T46, T53, T69, T80
Wear Part:
W28, W42, W45, W46
Consumables:
C3, C5, C11, C19, C22
31 Don't blow from above as this will dam-
age the sensor!
32 Clean the vacuum sensor from the side
only!
33 Lubricate slightly the O-ring and put it onto
the vacuum sensor.
34 Lubricate slightly the O-ring on the coil. 35 Align the plastic ring with the notch in the
housing.
36 Insert the coil to mount the PCBs onto the
housing.
21 6-monthly CPx+TH Appendix: Maintain the Pressure Regulator Valve (PRV) 10 min 7 / 7
CAUTION!Refer to safety instructions in user manual before commencing Mainten-
ance
NOTICE! ESD guidelines are to be followed Tool:
T44, T46, T53, T69, T80
Wear Part:
W28, W42, W45, W46
Consumables:
C3, C5, C11, C19, C22
37 Turn the 3 self tapping screws first to the
left checking for the thread before tighten-
ing them with a torque of 0,20 Nm.
38 Insert both plastic jackets and put on the
PCB.
39 Turn the 2 screws slightly to the left check-
ing for the thread before tightening them
with a torque of 0,20 Nm.
40 Put on the cover starting at the top (1) and
close it over the PCB (2). Turn the 2
screws slightly to the left checking for the
thread before tightening them with a
torque of 0,20 Nm.