00195467-01_Installation Manual Setup Center 2.2 - 第66页
SIPLACE Setup Center 2.2 Installation Manual Step 9 Overview of the se ttings Here you will see the overview of the settings. Click Back to review or change the settings. Click Next to continue the installation. St…
Installation Manual SIPLACE Setup Center 2.2
Step 8 Manual input of the PCB barcode
Note:
Traceability settings can only be changed, if the Tractability Option at the station
is installed.
If this checkbox is selected, the PCB barcode can be entered manually, in case that it was
not accepted from a barcode reader.
Click Next to continue.
65 of 90
-
SIPLACE Setup Center 2.2 Installation Manual
Step 9 Overview of the settings
Here you will see the overview of the settings.
Click Back to review or change the settings.
Click Next to continue the installation.
Step 10 Finishing the installation
Click Finish to end the installation.
66 of 90
Installation Manual SIPLACE Setup Center 2.2
5.3.2.2 Installing “Mobilink Patch”
When installing the Forced Setup Verification for placement stations which are supported via the
SMV interface, it is necessary to install a patch for the ‘mobilink.exe’. Currently the following
station software versions have to be updated.
• 407.04 SP1 and higher
• 503.04 SP2 and higher
• 505.03 SP1 and higher
Insert the CD “Mobi Patch SMV 1.3”. The installation starts automatically.
The dialog boxes shown below will be displayed during the installation procedure.
Note:
You are required to have administrator rights for the installation procedure!
Start Installation
Log on as administrator to the station PC
Place the Patch CD in your CD-ROM drive.
The following command window will appear.
Press any key to start the installation or close the window if you don’t want that
When installation is finished the command window looks like this:
67 of 90
-