OM-1078-002 - 第132页

2. Component Library Refer to "Section 3 Component Library" (the instruction manual (V ol. 3: Programming and Machine Data) of the main machine) for details. 2 .1 "Carrier Data" T ab The corresponding…

••

• Editing of Tray #2 Step Information Data

Operation Procedure

(1) When the step to be edited is selected in the "TRAY #2 STEP" tab

sheet (Fig. C12), the "Tray #2 Step Information" window opens.

Fig. C13 "Tray #2 Step Information" window

(2) Select the "Position Offset X status" text box and set Reference

Point X of the block.

(3) Select the "Position Offset X [mm]" text box and set the reference

coordinate of the tray based on the pallet reference position of the

block.

(4) Select the "Position Offset Y [mm]" text box and set the reference

coordinate of the tray based on the pallet reference position of the

block.

(5) When the "C" text box is selected, a control command can be set in

the text box.

1.3 "Placement Feeder Location" Tab

0311-002 3-11 AHI01EGP

2. Component Library

Refer to "Section 3 Component Library" (the instruction manual

(Vol. 3: Programming and Machine Data) of the main machine)

for details.

2.1 "Carrier Data" Tab

The corresponding tab sheet appears when "Cylindrical", "Square", "De-

form (Simple)", "Deform (Complex)", "Connector (Simple)", "Connector

(Complex)", "Other Leaded (Simple)", "Other Leaded (Complex)", or

"BGA/CSP" is selected in the "Component shape" text box.

••

• Sheet Layout

When the "Carrier Data" tab is pressed, the "Carrier Data" tab sheet

appears.

Fig. C14 "Carrier Data" Tab Sheet

••

• Sheet Composition

Refer to "4.1.3 Basic Usage of Text Boxes" in "Section 2" (the

instruction manual (Vol. 3: Programming and Machine Data) of

the main machine) for the details.

Enter parameters in these text boxes.

2. Component Library

0311-002 3-12 AHI01EGP

Note

3. System Setting

3.1 "Offset Data" Tab

3.1.1 "Tray #2" Tab

••

• Sheet Layout

Press the [SYSTEM] button on the main menu bar to open the "Ma-

chine System Data" window.

When the "Feeder B" tab is selected in the "Offset Data" tab sheet

and the "Tray #2" tab is pressed, the following tab sheet appears.

Fig. C15 "Tray #2" Tab Sheet

••

• Sheet Composition

*1 Tray step

Displayed are the step Nos.

*2 Block #1 through Block #9

X [mm] (Horizontal), Y [mm] (Vertical)

The set parameters are used to correct the variations in the indi-

vidual blocks of each step.

The values are based on the PL-XY coordinate system must be

entered in these text boxes.

Enter the positional deviations from the pickup position for each in-

dividual pallets, including the traverse drawout position (multi-layer

tray offset), such that components can be picked up at their cen-

ters.

3. System Setting

0311-002 3-13 AHI01EGP