OM-1078-002 - 第145页
1. 3 Preparation for Maintenance 1.3.1 Preparation for Cleaning Prepare the following items for cleaning. • Rag Use a rag which produces as less waste thread as possible. Other- wise, the machine will break down due to t…
1. Maintenance
1.1 Periodic Maintenance
1.2 Precautionary Items before Maintenance
This session describes how to perform inspections, cleaning, lubrica-
tion, and adjustment to keep the machine in good shape.
It is recommended that periodic maintenance of the machine should
be ensured.
Before lubrication, inspections, or cleaning work,
note the following items.
• Be sure to turn off the power switch and air
source of the machine and lock the power breaker
using the padlock.
Refer to "Precautionary Measures before
Maintenance Work" for details.
• Only qualified personnel should operate the ma-
chine carefully, following the specified
instruction.
• After cleaning with a rag, be sure to remove the waste thread com-
pletely. Otherwise, the machine will break down.
• Wipe off old grease before lubrication. Otherwise, the effect of grease
will decrease.
• When air is used for cleaning, do not blow air to any spots other than
the specified ones.
If dispersed dirt and dust adhere to various sensors, the ball screws,
the linear guides, etc., it may result in a breakdown of the machine.
• When a pallet is replaced with another one, check for damages,
cracks, bends, etc., to avoid any machinery breakdown and perform
the cleaning.
1. Maintenance
0311-003 4-2 AHI01EGP
WARNING
1.3 Preparation for Maintenance
1.3.1 Preparation for Cleaning
Prepare the following items for cleaning.
• Rag
Use a rag which produces as less waste thread as possible. Other-
wise, the machine will break down due to the remaining waste thread.
A clean rag is also required, depending on the spots to be cleaned.
• Oiled Rag
Use a rag which produces as less waste thread as possible. Other-
wise, the machine will break down due to the remaining waste thread.
Note: Do not apply too much oil to the rag. The oil should not be
mixed with another type.
1.3.2 Preparation for Lubrication
Prepare the specified grease and items for lubrication.
• Specified Grease
Refer to "(1) Grease" for details.
Before lubrication, wipe off the old grease.
Otherwise, the effect of grease will decrease.
• Specified Items for Lubrication
Refer to "(2) Brush" and "(3) Hand Grease Gun KH120" for details.
1.3 Preparation for Maintenance
0204-002 4-3 AHI01EGP
(1) Grease
• DAPHNE EPONEX GREASE No. 1
Same Types of Lubricants
• DAPHNE EPONEX GREASE No. 1 (IDEMITSU KOSAN) or its
equivalent
Table D1
Grease Names Makers
Alvania Grease No. 1 SHELL OIL
Multinoc Grease No. 1 Nippon Oil Corporation
Jomo Lisonix Grease No. 1 JAPAN ENERGY
Dynamax No. 1 COSMO OIL
Lithtan No. 1 ESSO OIL
MP Grease No. 1 KYGNUS OIL
Gemico MP No. 1 TonenGeneral Sekiyu K.K.
Multemp PS-1 KYODOH YUSHI
(2) Brush
Use a brush whose bristles do not come off if possible.
1.3 Preparation for Maintenance
0311-002 4-4 AHI01EGP