OM-1078-002 - 第93页

*6 [Clear Adj.] Button When pressed, this button clears the results of the teaching opera- tion. *7 [Cancel] Button When pressed, this button cancels the results of the teaching op- eration without reflecting them on the…

5.3 "TEACHING" Window (Submenu)

5.3.1 "Traverse Ofs" Tab

• Sheet Layout

When the "Traverse Ofs" tab is pressed in the "TEACHING" window

(submenu), the following tab sheet appears.

Fig. B9-1 "Traverse Ofs" Tab Sheet

• Sheet Composition

*1 "Select Head" Group Box

The following button is provided in this group box.

[Tray-2] Button

*2 "Select Option (Items to be taught)" Group Box

The following buttons are provided in this group box.

[All Beam Heads Zero] Button

When this button is pressed, all X/Y beams are zeroed.

[Teach Start] Button

0311-002 2-19 AHI01EGP

5.3 "TEACHING" Window (Submenu)

*6 [Clear Adj.] Button

When pressed, this button clears the results of the teaching opera-

tion.

*7 [Cancel] Button

When pressed, this button cancels the results of the teaching op-

eration without reflecting them on the offset data.

*8 [End] Button

When pressed, this button reflects the results of the teaching op-

eration on the offset data and exits from this session.

*9 "Control Switch" Group Box

Select the item (the button) to be taught and press the [ON] button

(entitled "MOVE"). After that, press the [ENABLE] button on the op-

eration panel in 2 seconds. A teaching operation is performed on

the selected item.

5.3 "TEACHING" Window (Submenu)

0204-001 2-20 AHI01EGP

5.3.2 "Pick-Up Location" Tab

Only a well-trained personnel shall perform teaching

operations.

The component library data and the pattern program

may be modified additionally for the teaching.

If the teaching operation is not performed correctly,

the pick-up rate may deteriorate.

• The pick-up position of the component at the multi-layer tray feeder is

taught through manual alignment operation.

The objective feeders for teaching are those whose pick-up position

is registered in the placement feeder location data of the current pat-

tern program.

The pick-up rate may be improved after the teaching of the pick-up

position is performed when the pick-up rate is low.

Menu selections become possible only when the machine is in

the "STOP" mode.

• Sheet Layout

When the "Pick-Up Location" tab is pressed in the "TEACHING" win-

dow (submenu), the following tab sheet appears inside the window.

Fig. B10 "Pick-Up Location" Tab Sheet

0311-002 2-21 AHI01EGP

5.3 "TEACHING" Window (Submenu)

Note

CAUTION