3OM-1208-011_w.pdf - 第292页
6-59 AIVEDT -ID [7] T rash box fill up warning mode Notice and Stop The quantity of waste tape is calculated according to the number of tape cuts determined in the carrier data ("T ape width [mm]", "T ape f…
6-58
AIVEDT-ID
Select
Cmpnt des
Select one of the following options to determine whether or not a
component should be designated for the recognized image to be saved.
No designate :
No component is designated.
Feeder No. :
A
feeder No. can be used to designate a
component.
Component ID :
A component ID can be used to designate a
component.
Feeder No.
When "Feeder No." is selected in the "Cmpnt des" text box, it is
required to enter the feeder No. to be designated.
Component ID
When "Component ID" is selected in the "Cmpnt des" text box, it is
required to enter the component ID to be designated.
Beam des
Select "No designate" or "Designate" to determine whether or not a
beam should be designated for the recognized image to be saved.
Beam
When "Designate" is selected in the "Beam des" text box, it is
required to select one of the following options (beams).
A
B C D
Nozzle des
Select "No designate" or "Designate" to determine whether or not a
nozzle should be designated for the recognized image to be saved.
Nozzle
When "Designate" is selected in the "Nozzle des" text box, it is
required to enter the No. of the nozzle to be designated.
Nozzle ID des
Select "No designate" or "Designate" to determine whether or not
a nozzle ID should be designated for the recognized image to be
saved.
Nozzle ID
When "Designate" is selected in the "Nozzle ID des" text box, it
is required to enter the nozzle ID to be designated.
0606-009
2.2 Auto Operation
6-59
AIVEDT-ID
[7] Trash box fill up warning mode
Notice and Stop
The quantity of waste tape is calculated according to the number of
tape cuts determined in the carrier data ("Tape width [mm]", "Tape feed
pitch [mm]", and "Type") of the component library data. This function
is used to calculate the amount of waste tape, issue a warning message
indicating that the trash box is full of waste tape, and perform the stop
operation of the machine.
Enter parameters in the "Notice" and "Stop" text boxes.
Note
When "0" is set in each text box, this function becomes invalid.
Counts of Tape Waste Chips
The counts of tape cuts differ, depending on the components being used.
[8] Cmpnt box fill up warning mode
Notice
Enter a parameter which represents the rate of component occupation in
the component box to be used to issue a warning message.
0606-009
2.2 Auto Operation
6-60
AIVEDT-ID
[9] Cutter operation setup
Cutters #1, #2, #3, and #4
Specify the following items for each cutter operation.
Mode
Select one of the following options to determine whether or not the
cutter function should be used.
Not Cut
After Pick up (length des)
When Transfer (length des)
When Transfer (every time)
Length des [mm]
Set the length of the tape to be cut by each cutter
.
Deceleration des
Select one of the following options to determine the rate of the speed
reduction.
Full Speed, 10%Decr
, 20%Decr, 30%Decr, 40%Decr,
50%Decr
, 60%Decr, 70%Decr, 80%Decr, 90%Decr
0606-009
2.2 Auto Operation