00195193-02 SG D4 FSE en (1) - 第249页
Component handling Overview Technical Data component table: S tudent Guide SIPLACE D4 (FSE) Component handling EN 09/2006 234 10.1.1 T echnical Data component t able: Feeder capacity 144 tracks width 8 mm (3x8mm S feeder…
Component handling
Overview
Student Guide SIPLACE D4 (FSE)
EN 09/2006 Component handling
233
10 Component handling
10.1 Overview
This chapter describes the preparation of components with the component changeover tables, the
corresponding docking unit and the pneumatic cutter.
Up to four flexible CO tables can be docked onto the D4 machine. The CO changeover tables are
automatically connected to/disconnected from the docking unit at the press of a button. Plug-in electrical
and pneumatic connections link the machine to the CO changeover table.
10.1 - 1: Shows the buttons for docking and undocking the COT‘s
The table unit consists of the CO changeover table and the mechanics for raising and lowering the CO
table.
Component handling
Overview Technical Data component table:
Student Guide SIPLACE D4 (FSE)
Component handling EN 09/2006
234
10.1.1 Technical Data component table:
Feeder capacity 144 tracks width 8mm (3x8mm S feeder)
96 tracks width 8mm (2x8mm S feeder)
Location 4 Component tables with the integrated tape waste container
12 tracks with 30 mm for each CO changeover table
undocking Tapes, Bulkcase, Linear magazin, Siplace S-Feeder(F4,F5,S-20,S-
23,S25HM,S27HM,HS50,HS50+,HS60), OEM Feeder, Surftape feeder (8, 12,
16, 24 mm), manual Trays
Interface to the
machine
Plug-in connection to machine
- Power supply
- CAN bus connection
- Closing the safety loop
- Compressed air connection
- Splice point recognition connection (optional)
Component table
height
depend from the machine height:
830 mm ± 15 mm (standard)
900 mm ± 15 mm (SMEMA)
930 mm ± 15 mm (SMEMA)
950 mm ± 15 mm (SMEMA)
Component handling
CO Changeover Table Construction (S Table) Overview
Student Guide SIPLACE D4 (FSE)
EN 09/2006 Component handling
235
10.1.2 CO Changeover Table Construction (S Table)
See also:
J 10.1 Overview [J 233]
Legend:
1. flexible base
2. Tape reels container
3. Handles
4. Tape waste container
5. Communication unit; Splice recognition unit
option is installed below the communication
unit
6. Feeder table plate
7. Switch for lowering the CO table
8. Slot for set up lists on both sides
9. Voltage 30 V communication unit (yellow LED)