80S-20用户手册 - 第459页
SIPLACE 80S -20/F4 User Manual 10 Component handling Software version SR.407.xx 01/2001 US Edition 10.7 Wafflepack Changer (80F4) 459 10 Fig. 10.7 - 5 A ligning the waff lepack changer (1) Wit h sock et wre nch U P/DO WN…
10 Component handling SIPLACE 80S-20/F4 User Manual
10.7 Wafflepack Changer (80F4) Software version SR.407.xx 01/2001 US Edition
458
10.7.9 Fitting the Wafflepack Changer
Å Before moving the WPC into the machine, remove the upper part of the camera of the compo-
nent vision module.
NOTE
The wafflepack changer can be moved into and out of the machine on its wheels, but it should be
noted that these wheels are not suitable for moving the wafflepack changer over longer distances.
DANGER OF OVERTURNING! In such cases use the suitable lift truck (from item no. 00123141-
01). 10
Å Move the wafflepack changer carefully into the desired location in the machine.The docking
pins of the wafflepack changer must be located above the docking slots of the SIPLACE ma-
chine.
Å Check the dimension (87 ± 0.5 mm) between lower edge of tray and top of component table
(see Fig. 10.7 - 5
).
SIPLACE 80S-20/F4 User Manual 10 Component handling
Software version SR.407.xx 01/2001 US Edition 10.7 Wafflepack Changer (80F4)
459
10
Fig. 10.7 - 5 Aligning the wafflepack changer
(1) With socket wrench UP/DOWN
(2) Clamping screw
(3) Stroke
(4) Docking pin
(5) Upper edge of the magnetic bar of the component table
(6) Lower edge of tray
(7) Nominal stroke (459 mm)
(8) Refill position (470 mm)
Å Undo the clamping screws at the feet (see Fig. 10.7 - 5) and using a 10 mm ball socket wrench
rotate the wafflepack changer downwards until the docking pin engages. The wafflepack
changer must at this point be aligned using the machine spirit level fitted to the wafflepack
changer.
Å Tighten up the clamping screws and check the machine spirit level again.
Å Reinstall the upper part of the camera on the component vision module.
10 Component handling SIPLACE 80S-20/F4 User Manual
10.7 Wafflepack Changer (80F4) Software version SR.407.xx 01/2001 US Edition
460
10.7.10 Technical Data
10
Wafflepack changer
Length approx. 1475 mm
Width approx. 620 mm
Height approx. 1355 mm
Weight approx. 240 kg
Magazine size 238 mm x 338 mm
Vertical stroke 470 mm
Horizontal stroke 730 mm
Pitch 17 mm
Storage unit capacity 28 trays for holding flatpack magazines
Tray 260 mm x 360 mm
Max. weight of storage unit 50 kg
Floor load < 25N/cm²
Max. magazine size 240 mm x 340 mm
Magazine height 15 mm, including component
Max. number of component types 200 per wafflepack changer
Changeover time (magazine/magazine) ≤ 3 sec.