EN 3.pdf - 第135页
Model DECAN Series Company SAMSUNG TECHWIN Module 3.9 DOCKING CART & FEEDER BASE V ersion 01 Tit le DOCKING CART OPERA TION CHECK Page 3-9-2 Note [DOCKING CART OPERA TION CHECK] 1. Check if the <Diagnosis> → &l…
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.9 DOCKING CART & FEEDER BASE
Total Pages
11
Table of Contents
[DOCKING CART OPERATION CHECK] ............................................................ 2
[FEEDER BASE SLOT SETTING] ....................................................................... 4
[FEEDER BASE SYSTEM OPTION CHANGE] ................................................... 6
[FEEDER CHAGE LOCATION CHANGE] ........................................................... 7
[FEEDER UNLOCK SESNOR SETTING] ............................................................ 8
[FEEDER BASE ASSEMBLY] ........................................................................... 10
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.9 DOCKING CART & FEEDER BASE
Version
01
Title
DOCKING CART OPERATION CHECK
Page
3-9-2
Note
[DOCKING CART OPERATION CHECK]
1. Check if the <Diagnosis> → <F2(I/O)> → <Sys.Setup> → <F4(Option)> → <Feeder Base System Option
> menu is set to <SM Docking 56>.
2. In < Feeder Base I/O>, use a feeder tool to check the I/O of < Feeder Slot #1~#56>.
3. When the Docking Cart is mounted in the equipment, see if the distance to the block is 20mm.
4. When moving up/down the mounted Docking Cart, see if horizontal levelness is maintained.
5. Check sensor IO depending on the mounting of the Docking Cart.
Classification SENSOR STATUS
IN PUT SENSOR
FRONT
LEFT/RIGHT
DOCKING CART
REAR
LEFT/RIGHT
DOCKING CART
OUT PUT SENSOR
FRONT/REAR DOCK
CART SOL_1_AIR
FRONT/REAR DOCK
CART SOL_1_UD
6. Using a Feeder I/O tool, turn on the feeder power and see if the IO signals such as <Output>,<Index> and
<Clamp> are normal.
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.9 DOCKING CART & FEEDER BASE
Version
01
Title
DOCKING CART OPERATION CHECK
Page
3-9-3
Note
7. Insert Feeder Origin tools in the Feeder Slot one by one and then check if the feeder gap sensor operates
properly.
Docking Type Feeder : 1. 28, 55
General Feeder : 1, 30, 59
8. If the Docking Feeder is used then check if the cover in the bottom front of the equipment is for docking.
9. Check if the Docking Feeder Prove Pin is ok.