EN 3.pdf - 第161页
Model DECAN Series Company SAMSUNG TECHWIN Module 3.1 1 HEAD T otal Pages 62 T able of Contents [HEAD BLOW & VACUUM SETTING (F 2)] ......................................................... 2 [HEAD BLOW & VACUUM S…
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.10 FEEDER
Version
01
Title
CONTROL BOARD REPLACEMENT
Page
3-10-16
Note
5. Connect the connector to the main board, while referring to the diagram below.
6. Cover assembly
7. Set it after finishing replacement.
- Home setting, Sensor initialization, Mapping
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.11 HEAD
Total Pages
62
Table of Contents
[HEAD BLOW & VACUUM SETTING (F2)] ......................................................... 2
[HEAD BLOW & VACUUM SETTING (L2)] ......................................................... 7
[HEAD EXTERIOR CHECK] .............................................................................. 12
[HEAD ASSEMBLY (F2)] ................................................................................... 13
[HEAD ASSEMBLY (L2)] ................................................................................... 15
[HEAD AMP ASSEMBLY (F2)] .......................................................................... 17
[HEAD AMP ASSEMBLY (L2)] .......................................................................... 22
[HEAD CABLE WIRING] .................................................................................... 24
[Z AXIS NOISE DECISION CRITERIA] ............................................................. 27
[HEAD SOLENOID VALVE REPLACEMENT (F2)] ........................................... 28
[HEAD SOLENOID VALVE REPLACEMENT (L2)] ............................................ 30
[NOZZLE HOLDER REPLACEMENT] ............................................................... 32
[BALL SPLINE REPLACEMENT (F2)] ............................................................... 33
[BALL SPLINE REPLACEMENT (L2)] ............................................................... 36
[LM GUIDE ASSEMBLY] ................................................................................... 39
[Z, R AXIS BELT TENSION ADJUSTMENT (F2)] ............................................. 40
[Z, R AXIS BELT TENSION ADJUSTMENT (L2)] .............................................. 41
[MOTOR DRIVER ASSEMBLY]......................................................................... 42
[Z, R AXIS SENSOR REPLACEMENT (F2)] ..................................................... 44
[Z, R AXIS SENSOR REPLACEMENT (L2)] ..................................................... 45
[Z, R AXIS MOTOR PULLEY REASSEMBLY (F2)] ........................................... 46
[Z, R AXIS MOTOR PULLEY REASSEMBLY (L2)] ........................................... 51
[FLY MIRROR REPLACEMENT] ....................................................................... 55
[MIRROR SWING MOTOR REPLACEMENT] ................................................... 56
[SWING CAM SET SCREW REASSEMBLY] .................................................... 57
[FIDUCIAL CAMERA LIGHTING LED CHANGE] .............................................. 58
[GREASE INJECTION (F2)] .............................................................................. 60
[GREASE INJECTION (L2)] .............................................................................. 61
[ROTARY JOINT REPLACEMENT (L2)] ........................................................... 62
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.11 HEAD
Version
01
Title
HEAD BLOW & VACUUM SETTING (F2)
Page
3-11-2
Note
[HEAD BLOW & VACUUM SETTING (F2)]
Check the Main Air Setting.
Check if the Digital Gauge is set to 0.5 Mpa (Spec 0.45~0.55Mpa) and if not reset it.
Check the air pressure level.
1. Select MMI <Diagnosis> → <Vacuum>.
2. While the Vacuum/Blow is Off, check the current level.
Check if the current level is 0±9 mmHg.
If not, adjust the VR of the Head IO Board.
3. Check the same thing for Gantry2's Head 11~20.