EN 3.pdf - 第282页
Model DECAN Series Company SAMSUNG TECHWIN Module 3.16 X-FRAME T otal Pages 15 T able of Contents [FX Z PHASE CHECK & COUPLING ASSE MBLY] ............................................. 2 [FLAT CABLE ASS EMBLY] .......…
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.15 PC RACK
Version
01
Title
PC RACK DUMMY SLOT SEPARATION
Page
3-15-12
Note
[PC RACK DUMMY SLOT SEPARATION]
1. Turn off the PC and turn off the Main Switch in the front of the equipment.
2. Separate the front cover from the equipment.
3. Separate the dummy slot cover to discharge heats from the inside of the PC rack.
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.16 X-FRAME
Total Pages
15
Table of Contents
[FX Z PHASE CHECK & COUPLING ASSEMBLY] ............................................. 2
[FLAT CABLE ASSEMBLY] ................................................................................. 3
[GREASE INJECTION] ........................................................................................ 5
[X AXIS NOISE DECISION CRITERIA] ............................................................... 6
[XY-DUCT X AXIS CABLE WIRING] ................................................................... 7
[XY DUCT INSPECTION] .................................................................................. 10
[XY EXTERIOR CHECK] ................................................................................... 11
[MOTOR DRIVER ASSEMBLY]......................................................................... 12
[LIMIT SENSOR REPLACEMENT] .................................................................... 14
[X AXIS LM GUIDE BOLT REASSEMBLY] ....................................................... 15
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.16 X-FRAME
Version
01
Title
FX Z PHASE CHECK & COUPLING ASSEMBLY
Page
3-16-2
Note
[FX Z PHASE CHECK & COUPLING ASSEMBLY]
1. Connect a two phase tool to the FX Command Connector.
2. Rotate the FX motor shaft to find the Z phase.
3. Move the X axis so that the FX axis Home Sensor and the Sensor Dog are separated by 6mm.
4. Using a torque wrench, fix the coupling on the X axis.