EN 3.pdf - 第283页
Model DECAN Series Company SAMSUNG TECHWIN Module 3.16 X-FRAME V ersion 01 Tit le FX Z PHASE CHECK & COUPLING ASSEMBL Y Page 3-16-2 Note [FX Z PHASE CHECK & COUPLING ASSEMBL Y] 1. Connect a two phase tool to the …
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.16 X-FRAME
Total Pages
15
Table of Contents
[FX Z PHASE CHECK & COUPLING ASSEMBLY] ............................................. 2
[FLAT CABLE ASSEMBLY] ................................................................................. 3
[GREASE INJECTION] ........................................................................................ 5
[X AXIS NOISE DECISION CRITERIA] ............................................................... 6
[XY-DUCT X AXIS CABLE WIRING] ................................................................... 7
[XY DUCT INSPECTION] .................................................................................. 10
[XY EXTERIOR CHECK] ................................................................................... 11
[MOTOR DRIVER ASSEMBLY]......................................................................... 12
[LIMIT SENSOR REPLACEMENT] .................................................................... 14
[X AXIS LM GUIDE BOLT REASSEMBLY] ....................................................... 15
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.16 X-FRAME
Version
01
Title
FX Z PHASE CHECK & COUPLING ASSEMBLY
Page
3-16-2
Note
[FX Z PHASE CHECK & COUPLING ASSEMBLY]
1. Connect a two phase tool to the FX Command Connector.
2. Rotate the FX motor shaft to find the Z phase.
3. Move the X axis so that the FX axis Home Sensor and the Sensor Dog are separated by 6mm.
4. Using a torque wrench, fix the coupling on the X axis.
Model
DECAN Series
Company
SAMSUNG TECHWIN
Module
3.16 X-FRAME
Version
01
Title
FLAT CABLE ASSEMBLY
Page
3-16-3
Note
[FLAT CABLE ASSEMBLY]
1. Assemble it carefully so that the air pressure line does not cause damage to the Rubber of the Flat Cable
Guide.
2. Insert a tool between the air tube and the guide inside the Flat Cable.(insertion location : end of R.)
3. Insert and assemble the guide mat into the outside/insider of the Flat Cable.
4. Tie the three cables.