2OM-1088-002.pdf - 第332页
Tg0699-PM-D2 5. Weekly Maintenance 5. Weekly Maintenance DE1: DAPHNE EPONEX GREASE No. 1 Fig. 5A14 P .C.B. Chuck Section Upper Surface of Backup T able and Pin Hole Section Cleaning Remove solder paste and dust with a va…
Tg0699-PM-D2
Glass Surface of P.E.C.
Recognition Lighting
Remove dirt and dust with
a vacuum cleaner.
Clean
Fig. 5A12 R Conveyor Section
4. Daily Maintenance
0207-001 Chapter 3 1-12
Fig. 5A13 P.E.C. Recognation Section
Upper Surface of P.C.B.
Transfer Belt
Remove solder paste and
dust with a vacuum cleaner.
Clean
Tg0699-PM-D2
5. Weekly Maintenance
5. Weekly Maintenance
DE1: DAPHNE EPONEX GREASE No. 1
Fig. 5A14 P.C.B. Chuck Section
Upper Surface of Backup
Table and Pin Hole Section
Cleaning
Remove solder paste and
dust with a vacuum cleaner.
Table 5A5
Maintenance Spots
Description
Grease
Cleaning
Check
Tools,
Nozzles,
etc.
P.C.B. Chuck Upper Surface of 5A14 Cleaning - Vacuum
Section Backup Table and Cleaner
Pin Hole Section
P.E.C. P.C.B. Stopper 5A15 Cleaning DE1 Oiled Rag
Recognition P.C.B. Warpage 5A15 Cleaning - Rag
Section Top Holder
(Outer Circumfe-
rence of Roller)
Air Source Drain 5A16 Cleaning - Container,
etc.
L Conveyor Interlock 5A17 Cleaning - Vacuum
Section Cleaner
R Conveyor Interlock 5A18 Cleaning - Vacuum
Section Cleaner
Blower Filter 5A19 Cleaning - Air and
Vacuum
Cleaner
0509-002 Chapter 3 1-13
Block Name Detailed Name
Fig.
No.
Tg0699-PM-D2
P.C.B. Stopper
Clean the stopper with an
oiled rag.
Note : Remove waste thread
if any.
Cleaning
P.C.B. Warpage Top Holder
(Outer Circumference of
Roller)
Remove dirt on the outer
circumference of the roller
with a soft cloth, etc.
Cleaning
Fig. 5A16 Air Source
Fig. 5A15 P.E.C. Recognition Section
5. Weekly Maintenance
Drain
Follow the steps below to purge the drain.
(1) Put a container under the drain outlet.
(2) Slowly turn the cap (located on the housing
bottom of each air filter) in Arrow Direction A.
Note: If the cap is turned excessively, dirty
water will gush out.
Cleaning
Cap
#
0207-001 Chapter 3 1-14