2OM-1088-002.pdf - 第340页
Tg0699-PM-D2 Fig. 5A25 P .C.B. Chuck Section 6. Monthly Maintenance 0207-001 Chapter 3 1-21 Linear Guide for P .C.B. Clamping Clean the guide with a brush. Note : Remove waste thread if any . Clean the linear guide using…
Tg0699-PM-D2
Buckup Table Z-Axis Guide
Bushing
Clean the guide bushing
with an oiled rag.
Note : Remove waste thread
if any.
Cleaning
Linear Guide for Chute
Width Adjustment
Clean the guide with an
oiled rag.
Note : Remove waste thread
if any.
Cleaning
Fig. 5A22 Table Section
6. Monthly Maintenance
Fig. 5A23 P.C.B. Chuck Section
0207-001 Chapter 3 1-20
θ-Axis Linear Guide
Clean the guide with an
oiled rag.
Note : Remove waste thread
if any.
Cleaning
Tg0699-PM-D2
Fig. 5A25 P.C.B. Chuck Section
6. Monthly Maintenance
0207-001 Chapter 3 1-21
Linear Guide for P.C.B. Clamping
Clean the guide with a brush.
Note : Remove waste thread if any.
Clean the linear guide using the following procedure.
Select "Chute Open" in the "Jig Change Mode" on the "Backup Jig Change" tab on the
"PRODUCT CHG." submenu window in the "SPECIAL SEL." menu.
Cleaning
Fig. 5A24 P.C.B. Chuck Section
Spline for Chute width
Adjustment
Clean the spline with a
Brush.
Note : Remove waste thread
if any.
Lubrication
Tg0699-PM-D2
Fig. 5A26 P.E.C. Recognition Section
Fig. 5A27 P.E.C. Recognition Section
Fig. 5A28 Squeegee Head Section
6. Monthly Maintenance
0207-001 Chapter 3 1-22
X-Axis Linear Guide
Clean the guide from the
rear side, with an oiled rag.
Note : Remove waste thread
if any.
Cleaning
Clean the guide with an
oiled rag.
Note : Remove waste thread
if any.
Cleaning
Y-Axis Linear Guide
Clean the guide with an
oiled rag.
Note : Remove waste thread
if any.
Cleaning
Y-Axis Linear Guide