00198442-04_UM_TX-V2_EN - 第15页

Instruction manual SIPLACE TX 1 Introduction From software version 714.0 12/2020 15 1 Introduction This instruction manual is a gui de o r reference wo rk for o perat ing and setting up the SIPLACE ® TX Edition V2 placem…

Contents Instruction manual SIPLACE TX

From software version 714.0 12/2020

Instruction manual SIPLACE TX 1 Introduction

From software version 714.0 12/2020

1 Introduction

This instruction manual is a guide or reference work for operating and setting up the SIPLACE

TX Edition V2 placement machines.

The SIPLACE TX Edition V2 placement machines are available in six different variants:

– SIPLACE TX1

– SIPLACE TX2

– SIPLACE TX2i

– SIPLACE TX2 m

– SIPLACE TX2i m

– SIPLACE TX2i m 4 mm

The numbers in the type name indicate the number of gantries used. Each gantry has one place-

ment head. The term m stands for enhanced placement accuracy of 15 µm, 20 µm or 25 µm

The header of each chapter contains the release and software version, to which this manual ap-

plies.

PLEASE NOTE

The SIPLACE TX Edition V2 placement machines are of largely identical design. Any dif-

ferences will be mentioned specifically.

 For information about the relevant configurations and options, please refer to the

specification documentation for the SIPLACE TX or SIPLACE TX m.

The diagrams in this instruction manual show the SIPLACE TX2. These diagrams also

apply in principle to the SIPLACE TX1, TX2i or SIPLACE TX m. Additional diagrams will

be shown for any deviations.

1 Introduction Instruction manual SIPLACE TX

1.1 Important notes on the instruction manual From software version 714.0 12/2020

1.1 Important notes on the instruction manual

1.1.1 Contents and filing of the instruction manual

This instruction manual contains basic information that must be observed when setting up, oper-

ating and maintaining the placement machine. The service engineers, qualified staff, operators

and users plus system owner must therefore read it before commencing installation and commis-

sioning. The instructions must be kept permanently accessible where the placement machine is

used.

In addition, the user must ensure that the employees have fully understood the contents of the

instruction manual.

1.1.2 Danger notes

1.1.3 Manufacturer's/supplier's liability

We hereby confirm that the contents of this instruction manual are of a descriptive and explanatory

nature only and do not contain any contractual conditions or guaranties. The liability and obliga-

tions assumed by ASM Assembly Systems GmbH&Co.KG can be found exclusively in the rele-

vant contract agreement concerning the supply of the placement machine described in this

manual. This applies in particular to all statements regarding performance or service life and the

agreed liability for faults or defects. The provisions of the contract regarding the liability for faults

or defect are neither extended nor restricted by any statements in this instruction manual.

WARNING

Read the instruction manual!

 Tasks may only be performed by qualified staff who have completed the relevant

training.

 Only perform tasks on the placement machine if you have precise knowledge of the

relevant section in the instruction manual.

 Observe all warnings, caution notes and hazard notes.

 Please also read chapter 2 of this instruction manual through carefully.