00198442-04_UM_TX-V2_EN - 第168页
3 Technical data and assemblie s Instruction manual SIPLACE TX 3.9 Component trolley From software version 714.0 12/2020 168 3.9.4 SIPLACE TX-Series changeover table The front slider guides o f the feeder modules are pla…
Instruction manual SIPLACE TX 3 Technical data and assemblies
From software version 714.0 12/2020 3.9 Component trolley
167
3.9.3 Fiducials on the SIPLACE TX-Series component trolley
3
Fig. 3.9 - 3 Fiducials on the SIPLACE TX-Series component trolley
(1) Fiducials on the component trolley
Once the SIPLACE TX component trolley has been docked in, the placement machine measures
the fiducials on the component trolley.
In the case of components with an edge length less than 0.5 mm, meaning 0402 components and
smaller, the position of the component is determined with the tape pocket, when the setup is spec-
ified or when the start button is pressed after the table or feeder has been removed.
(1)
3 Technical data and assemblies Instruction manual SIPLACE TX
3.9 Component trolley From software version 714.0 12/2020
168
3.9.4 SIPLACE TX-Series changeover table
The front slider guides of the feeder modules are placed on the insertion aid. As it is pushed in,
the guides of the feeder module slide on the guide profile as far as the stop bar. A centering hole
on the stop bar holds the "front" centering pin of the X feeder module. At the same time, the locking
latch of the changeover table latches onto the locking roller of the feeder module. The "back" cen-
tering pin on the top of the feeder module is held by the recess in the centering bar.
3
Fig. 3.9 - 4 Changeover table, SIPLACE TX-Series, rear view
(1) Insertion aid
(2) Guide profile (Ω profile)
(3) Centering bar for holding the "back" centering pin for X feeder modules
(4) Centering holes
(5) Stop bar
(1)
(2)
(3)
(4)
(5)
Instruction manual SIPLACE TX 3 Technical data and assemblies
From software version 714.0 12/2020 3.9 Component trolley
169
3
Fig. 3.9 - 5 Changeover table, SIPLACE TX-Series, front view
(1) Centering hole on the changeover table
(2) Locking latches
(3) Centering pin on the changeover table
(1)
(2)
(3)