00198442-04_UM_TX-V2_EN - 第214页

4 Setting up and commissioning In struction manual SIPLACE TX 4.7 Commissioning the placement m achine From software version 71 4.0 12/2020 214 4.7.2.1 Performing initial calibrati on  Click on "Service T ools&quot…

Instruction manual SIPLACE TX 4 Setting up and commissioning

From software version 714.0 12/2020 4.7 Commissioning the placement machine

213

4.7 Commissioning the placement machine

4.7.1 Commissioning the placement machine at the customer's premises

 Check all modules for correct seating.

 Remove the shipping braces (see section 4.5.2, page 195).

 Wipe the linear guide rails of the X/Y axis with a lint-free cloth. Do not use any solvents (see

section 4.5.4

, page 198).

 Connect the power and compressed air supplies. Make sure that the incoming leads and ca-

bles can not be tripped over. If possible, run the incoming cables under the placement ma-

chine.

 Switch the placement machine on and check the function of the safety features such as the

EMERGENCY STOP button, position switch for covers and the component trolley.

 Perform a reference run.

 Perform initial calibration of the placement machine (see section 4.7.2.1, page 214).

 Load a recipe in the computer and test it.

 Check the placement machine zero point after a period of warming up of 3 - 4 h.

 Get the customer's operating personnel to equip the feeder modules according to the cus-

tomer's placement program.

 Instruct them in handling the feeder modules using the JobGuide.

4.7.2 Checking and setting the protective cover switch

 Check the function of the protective cover switch (see 2.4.1 on page 73).

 Adjust the protective cover switch if necessary (see service manual).

4 Setting up and commissioning Instruction manual SIPLACE TX

4.7 Commissioning the placement machine From software version 714.0 12/2020

214

4.7.2.1 Performing initial calibration

 Click on "Service Tools" in the toolbar.

 Click on the Automatic calibration button.

Fig. 4.7 - 1 Service tools => automatic calibration

 Select Selection => Gantry axis calibration (1).

(1)

Instruction manual SIPLACE TX 4 Setting up and commissioning

From software version 714.0 12/2020 4.7 Commissioning the placement machine

215

Fig. 4.7 - 2 Service tools => automatic calibration => calibrating the gantry axes

The following calibration steps are enabled:

– 1. Travel range

– 3. System identification

– 4. Parameterization X axis

 Click on Next (1).

The calibration must be completed without errors.

(1)