00198442-04_UM_TX-V2_EN - 第257页
Instruction manual SIPLACE TX 5 Tasks at the placement machine From software version 714.0 12/2020 5.10 Setting up the feeder mo dules 257 Pull the cover foil at the side of the pick-up w indow forward a nd out underne…
5 Tasks at the placement machine Instruction manual SIPLACE TX
5.10 Setting up the feeder modules From software version 714.0 12/2020
256
5
Fig. 5.10 - 5 Pickup window on the tape feeder module
(1) Tape support, removable (see section 5.10.4.4, page 258)
(2) Pickup window
(3) Removal edge for the cover foil
(4) Component pickup area
(5) Lever for raising and latching the pick-up window
On the operator panel, press the FORWARD button (item 1 in fig. 5.10 - 6) until the bend of
the cover foil is in the component pickup area (item 4 in fig. 5.10 - 5
).
5
Fig. 5.10 - 6 Operating panel with LED display
(1) FORWARD button for moving the component tape forward
(2) BACK button for moving the component tape back
(3) FOIL button for tensioning the cover foil
Push the lever (item 5 in fig. 5.10 - 5, page 256) forward in order to raise the pickup window
(item 2 in fig. 5.10 - 5
, page 256) into the first latching position.
(1)
(2)
(3)
Instruction manual SIPLACE TX 5 Tasks at the placement machine
From software version 714.0 12/2020 5.10 Setting up the feeder modules
257
Pull the cover foil at the side of the pick-up window forward and out underneath the pick-up
window.
Fold the cover foil back until it lies against the pull-off edge (item 3 in fig. 5.10 - 5, page 256).
5
Push the lever (item 5 in fig. 5.10 - 5, page 256) back to lower the pickup window.
Guide the cover foil over the cover foil rocker (item 2 in fig. 5.10 - 7) until it reaches the foil
packing wheels (item 1 in fig. 5.10 - 7
).
5
Fig. 5.10 - 7 Guiding the cover foil to the foil packing wheels
(1) Cover foil packing wheels
(2) Cover foil
5
On the operator panel, press the FOIL button (item 3 in fig. 5.10 - 6, page 256) until the cover
foil is tensioned. The cover foil rocker points down and stops the drive motor.
Cut the component tape flush with the front end of the feeder module.
PLEASE NOTE
Do not lower the pick-up window until the cover foil is lying against the pull-off edge.
(1)
(2)
5 Tasks at the placement machine Instruction manual SIPLACE TX
5.10 Setting up the feeder modules From software version 714.0 12/2020
258
5.10.4.4 Splice sensors
Splice sensors can be retrofitted to the SIPLACE SmartFeeder.
SIPLACE SmartFeeders with a splice sensor already installed can also be supplied (see section
3.8
, from page 153).
5.10.5 Configuring components on the SIPLACE SmartFeeder
The operation and setting up is described in the SIPLACE SmartFeeder X /Xi job guides.