1_H24维修手册.pdf - 第131页

E d it io n 5 .0 H 24 H ead R ep ai r T r ai n i n g T ext f o r S er vi ce E n g i n e e r Pro p e r D at a M e asu r em en t 7. T he f ol l ow i ng m es s a ge d i s pl ay s w hen m o v i ng t o t he pos i t i on f or …

Edition 5.0 H24 Head Repair Training Text for Service Engineer

Proper Data Measurement

5. In order to make the measurement easier, lower the Z axis and tighten the coupling

where the jig is parallel to the X-axis and the pulse count at this position is 30000 ±

3000 pulses. The servo counter at this position will be the proper data for A-holder

Q-axis.

(Coupling tightening torque: 0.4 Nm)

6. This manual explains the measurement by using [ALL], so after the A-holder Q-axis

proper data measurement, select [OK] to automatically rotate the R-axis to move to

the B-holder proper data measurement.

Pins should

align vertically

FK-9F50-08-0E 10-12 FUJI MACHINE MFG. CO., LTD

CONFIDENTIAL

Downloaded at 2015/06/18 12:05:48 (JST) by 5LUF0998

Edition 5.0 H24 Head Repair Training Text for Service Engineer

Proper Data Measurement

7. The following message displays when moving to the position for the B-holder Q-

axis measurement. Check that the Z-axis is at the upper end position, and then

press [OK].

8. Perform the proper data measurement in the same way for syringe B and the other

remaining syringes.

Once the proper data measurement is complete for all the syringes,

select [Next] to begin the Z-axis proper data measurement.

Axis move! Z position OK?

FK-9F50-08-0E 10-13 FUJI MACHINE MFG. CO., LTD

CONFIDENTIAL

Downloaded at 2015/06/18 12:05:48 (JST) by 5LUF0998

Edition 5.0 H24 Head Repair Training Text for Service Engineer

Proper Data Measurement

10.7 Z-axis Proper Data Measurement

1. Perform MT reset at the Z-axis upper end.

2. Set the Z-axis counter value to -19750, and then loosen the coupling and push the Z-

axis up/down lever cam follower lightly against the syringe arm (Top of the syringe

pusher). Then tighten the four coupling bolts equally. (Tightening torque wrench

0.4Nm).

(It is better to turn the servo ON or use the ABS to stop the Z-axis counter moving

during this measurement.)

3. The following screen displays after performing MT reset. Proceed to the upper limit

position measurement.

Evenly tighten 4

bolts. 0.4Nm

Cam follower

Arm

FK-9F50-08-0E 10-14 FUJI MACHINE MFG. CO., LTD

CONFIDENTIAL

Downloaded at 2015/06/18 12:05:48 (JST) by 5LUF0998