1_H24维修手册.pdf - 第150页

Edition 5.0 H24 Head Re pair T raining T ext for Ser v ice Enginee rs Camer a posi t ion adjus t ment, curr ent value (gr ays cale value ) a djustmen t a nd area ch ec k FK -9F50- 08-0E 1 1 -10 FU JI MACHINE MFG . CO., L…

Edition 5.0 H24 Head Repair Training Text for Service Engineers

Camera position adjustment, current value (grayscale value) adjustment and area check

FK-9F50-08-0E 11-9 FUJI MACHINE MFG. CO., LTD.

11.5. Adjusting the Camera Installation Position

1. Open the Equipment check and turn the head power ON. Then startup the

MotionAdjustmentTool. Move the R axis so that the A-holder faces the front side of the

head. Refer to the procedure “11.2 Preparation on the module”.

2. Press and hold the lower button for a few seconds to shift to “ADJ MODE”.

3. Press the lower button to shift to “ADJUSTMENT 1”.

CONFIDENTIAL

Downloaded at 2015/06/18 12:05:48 (JST) by 5LUF0998

Edition 5.0 H24 Head Repair Training Text for Service Engineers

Camera position adjustment, current value (grayscale value) adjustment and area check

FK-9F50-08-0E 11-10 FUJI MACHINE MFG. CO., LTD.

4. Use MotionAdjustmentTool to check the A holder is at the front of the head (the

position where the B and X holders are aligned).With holder A at this position, adjust

the position of the camera so that the jigs on the B and X holders match up with the

green frames on the screen.

5. Use the bolts below to adjust the camera position so that the center value, resolution and tilt

are all within tolerance.

The jigs match the

green frames on the

screen.

CONFIDENTIAL

Downloaded at 2015/06/18 12:05:48 (JST) by 5LUF0998

Edition 5.0 H24 Head Repair Training Text for Service Engineers

Camera position adjustment, current value (grayscale value) adjustment and area check

FK-9F50-08-0E 11-11 FUJI MACHINE MFG. CO., LTD.

Inspection item Tolerance Target value

Camera resolution

L: X = 92~108

L: Z = 92~108

Same as tolerance

Center value R: Xs = 380~400, Zp = 235~255

L: Xp = 80~100, Zp = 237~253

R: Xs = 390, Zp = 245

L: Xp = 90, Zp = 245

Tilt R: dX = 0~6, dZ = 0~9

L: dX = 0~6, dZ = 0~9

R: dX = 0, dZ = 0

L: dX = 0, dZ = 0

6. If the results are within tolerance, press the lower button to save the settings.

7. Once saving the settings, remove the jig nozzles (2AGKNJ001500).

Resolution

Center value

Tilt

CONFIDENTIAL

Downloaded at 2015/06/18 12:05:48 (JST) by 5LUF0998