4M184002w_F8S - 第120页

4OM-1840 1-4-45 1604-001 4.9.2 Ball Screw Cleaning and Oiling Cycle : Every 3 Months (Required Time : 10 minutes) Grease : DAPHNE GREASE MP No.1 Ball Screw Fig. 4A4-57 Procedure (1) W ipe old grease out using a rag. (2) …

4OM-1840

1-4-441604-001

4.9.1 Backup Table Upper Surface Cleaning

Cycle : Every Week (Required Time : 2 minutes)

Backup Table Upper Surface

Fig. 4A4-56

Procedure

Remove foreign substances and unrequired components and suck dirt and dust

with a vacuum cleaner.

Note

Either Y510mm or Y250mm single transfer unit can be selected when the system is

delivered from the factory.

4.9 PCB Positioning Section

4OM-1840

1-4-451604-001

4.9.2 Ball Screw Cleaning and Oiling

Cycle : Every 3 Months (Required Time : 10 minutes)

Grease : DAPHNE GREASE MP No.1

Ball Screw

Fig. 4A4-57

Procedure

(1) Wipe old grease out using a rag.

(2) Apply new grease on the screw shaft using a syringe.

Note

Perform the cleaning operation using the same procedure also in the system where the

Y510mm Single Transfer Unit (Factory option) has been mounted.

4.9 PCB Positioning Section

4OM-1840

1-4-461604-001

4.9 PCB Positioning Section

4.9.3 Ball Screw Spline Cleaning and Oiling

Cycle : Every 6 Months (Required Time : 10 minutes)

Grease : DAPHNE GREASE MP No.1

Grease Nipple

Ball Screw Spline

(Under side of Backup Table)

Fig. 4A4-57-1 Y510 mm Single Transfer Unit

Note

Either Y510mm or Y250mm single transfer unit can be selected when the

system is delivered from the factory.

Procedure

(1) Wipe out old great using a cloth.



(2) Attach the micro hose onto the hand grease gun and apply new grease from

the grease nipple.

Note

The nozzle to be used should be SPK-3C.

Fig. 4A4-57-2