4M184002w_F8S - 第126页

4OM-1840 1-4-51 1604-001 4.10.3 PCB Detection Sensor Cleaning Cycle : Every Week (Required Time : 2 minutes) PCB Detection Sensor The light receiving section is located inside these sections in the figure. Fig. 4A4-63 Pr…

4OM-1840

1-4-501604-001

4.10.2 Support Pin Detection Sensor Cleaning

Cycle : Every Week (Required Time : 1 minute)

Support Pin Detection Sensor

Fig. 4A4-62

Procedure

Clean the support pin detection sensors with a rag.

Note

Perform the cleaning operation using the same procedure also in the system where the

Y510 mm Single Transfer Unit (Factory option) has been mounted.

4.10 Conveyor Section

4OM-1840

1-4-511604-001

4.10.3 PCB Detection Sensor Cleaning

Cycle : Every Week (Required Time : 2 minutes)

PCB Detection Sensor

The light receiving section is

located inside these sections

in the figure.

Fig. 4A4-63

Procedure

Clean the PCB detection sensor light emitting and receiving sections using a rag.

Note

Perform the cleaning operation using the same procedure also in the system where the

Y510 mm Single Transfer Unit (Factory option) has been mounted.

4.10 Conveyor Section

4OM-1840

1-4-521604-001

4.11 Nozzle Stocker Section

Nozzle Storage Section

Every Month Cleaning

Shutter Flange Pin Sliding Section

Every 3 Months Cleaning and Lubrication

(MOLYNOC GREASE AP1)

Required Time: 5 minutes

Nozzle Stocker Sliding Section

Every 3 Months Cleaning and Lubrication

(DAPHNE EPONEX GREASE No. 1)

Required Time: 5 minutes

Fig. 4A4-65

4.11 Nozzle Stocker Section