4M184002w_F8S - 第84页
4OM-1840 1-4-9 1604-001 4.2.2 Filter Cleaning Cycle : Every 3 Months (Required Time : 10 minutes) Filter Case C Filter Fig. 4A4-10 Procedure (1) Remove four setscrews fastening the cover located at the lower area of the …
4OM-1840
1-4-81604-001
4.2.1 Vacuum Pressure Check
Cycle : Every Day (Required Time: 1 minute)
Vacuum Pressure
Fig. 4A4-9
Procedure
Check the vacuum pressure visually.
Vacuum Valve Fully Closed : Min. -93 kPa (Min. 70 cmHg) or more
Running : Min. -60 kPa (Min. 45 cmHg) or more
Note
line or the vacuum pump may have broken down.
4.2 Vacuum System
4OM-1840
1-4-91604-001
4.2.2 Filter Cleaning
Cycle : Every 3 Months (Required Time : 10 minutes)
Filter Case
C
Filter
Fig. 4A4-10
Procedure
(1) Remove four setscrews fastening the cover located at the lower area of the
front side of the machine and detach the cover.
Note
When the vacuum pressure has dropped during the operation, replace the
(4) Attach the cover and tighten the setscrews.
Notice
If a clearance is left between the main machine and the cover, the
tape will pop out from the clearance during the operation, causing
the machine to breakdown or generate an error.
4.2 Vacuum System
4OM-1840
1-4-101604-001
4.3 Component Recognition Camera Section
NOTICE
Do not put your hand onto the ducial mark block.
If too much force is given to the ducial mark block it
may become deformed.
Fiducial Mark Block
Component Recognition Camera
(4 locations)
Every Day Cleaning
Required Time: 4 minutes
Fig. 4A4-11
Fiducial Marks (4 locations)
Every Week Cleaning
Required Time: 2 minutes
Component Storage Box
Every Day Cleaning
Required Time: 1 minute
Fig. 4A4-12
Note
These options are selected together with the SIGMA-F8S high-speed
multi-purpose head as a factory set when the system is delivered from the
factor.
4.3 Component Recognition Camera Section