SIPLACE Station Software 7xx to 714 介绍 - 第201页
Station Software 7xx to 714.0 (R20-2) / Feature Description 11/2020 Edition 201 With the Capture images butt on, pictures are taken of the positio ns by the board camera. The measurement is performed f or one lane only a…
Station Software 7xx to 714.0 (R20-2) / Feature Description 11/2020 Edition
200
10.13.6 Camera Connections – Checking Gig E Interface
A new GUI dialog will provide information about the current health states of permanently installed
Gig E cameras and all intermediate stations.
Figure 10-25: Checking camera connections
NOTICE
This feature does not support checking Coplan sensors.
10.13.7 Conveyor Rail Verification
Compatible mode: Complete
With the Conveyor rail verification button in the Verification view, the parallelism of the conveyor
rails can be checked. For this, several X positions per processing area (currently 5) are displayed
at the outer edges of the rails.
Figure 10-26: Displayed X positions
Station Software 7xx to 714.0 (R20-2) / Feature Description 11/2020 Edition
201
With the Capture images button, pictures are taken of the positions by the board camera.
The measurement is performed for one lane only and the results are displayed on the GUI. For
dual conveyors, there will be two independent measurements and result views. The pictures must
be inspected by the operator.
It is possible to perform the measurements with boards in the conveyor, but not during production.
The machine must be stopped before the measurements can be started.
With the Generate report button, a report can be created that contains a screenshot of the page.
Figure 10-27: Result view of a machine with two processing areas
The report is stored at the station.
Station Software 7xx to 714.0 (R20-2) / Feature Description 11/2020 Edition
202
10.13.8 Conveyor Motor Verification
With the Conveyor motor verification in the Verification view, all current motors of the conveyor
can be verified (lifting tables, width adjustment and belt motors). The results are displayed together
with the limits (green mark if within the limits, red cross if outside the limits).
Figure 10-28: Verifying conveyor motors
The functionality is not supported on SIPLACE X-series conveyors.
Restrictions
No support on X-series conveyors.