Schneller MTC Wechseltisch - 第27页
Special design Assembly instructions Changeover table in place of the MTC2 03/2007 Edition 27 2 Assembly instructions: S pecial design for changeover t able in place of the MTC2, SIPLACE HF series (SW 505.03, 505.03 SP 1…
1 Montageanleitung SOKO Wechseltisch anstelle des MTC2 (SW 505.03, 505.03 SP 1, 505.04) SIPLACE HF-Serie SOKO
Ausgabe 03/2007
26
1.13 Stromlaufplan
1
Abb. 1.10 - 1 Stromlaufplan
Special design Assembly instructions Changeover table in place of the MTC2
03/2007 Edition
27
2 Assembly instructions:
Special design for changeover table
in place of the MTC2, SIPLACE HF
series (SW 505.03, 505.03 SP 1,
505.04)
2.1 Description of the functions
If the changeover table is installed, it can be set up on an HF or HF/3 feeder in place of the MTC2
at location 2 without having to replace the docking unit frame. 2
A JEDEC tray may be placed on the front cover plate. The programming guide for the arbitrary
carrier under SIPLACE Pro (Item no.: 00194607-xx) is provided for this purpose. 2
2
Assembly instructions Changeover table in place of the MTC2 Special design
03/2007 Edition
28
2.2 Requirements
2.3 Restrictions
It is not possible to use a 3rd tape reel with 3 x 8mm feeders as there is no suspension point for
the 3rd reel on the tape reel holder. 2
There is no tape cutter, which means that the component tapes must be cut off beneath the ma-
chine from time to time.
The machine must be stopped first. 2
The table may only be installed at location 2. The necessary changes to the software have not yet
been made for installation at location 4. 2
The special design software must be reinstalled after a software upgrade or a service pack instal-
lation. Please note the requirements. 2
After the installation of the special design "MTC-changeover table" the distributor must not be
started manually from the operating system. 2
No linear feeders can be mounted. 2
2.4 Deliverables
– Changeover table
– 2 screws M8 x 45 mm
– 2 magnets
– CD for software settings
– Sssembly instructions: Special design for changeover table in place of MTC2 (item no.:
00194578-xx)
– Arbitrary carrier programming guide (Item no.: 00194607-xx)
2.5 Tools required
– T-shaped Allen key, size 8
Software
Station software 505.03, 505.03 SP 1 and 505.04
Hardware
HF or HF/3 with MTC 2 at location 2