Schneller MTC Wechseltisch - 第31页
Special design Assembly instructions Changeover table in place of the MTC2 03/2007 Edition 31 2 2 2 2 2 2 2 2 2 2 2 2 2 2 Cable for t able communication
Assembly instructions Changeover table in place of the MTC2 Special design
03/2007 Edition
30
2.7 Converting to changeover table
: Remove the MTC2 from the placement machine as described in the instructions.
: Push the changeover table into the guide rail until it engages on the rear centering pins.
Watch out for the table communication cable which runs down between the docking unit frame
and machine.
Fix the table using the screws provided.
2
2
2
2
2
2
2
2
Special design Assembly instructions Changeover table in place of the MTC2
03/2007 Edition
31
2
2
2
2
2
2
2
2
2
2
2
2
2
2
Cable for table communication
Assembly instructions Changeover table in place of the MTC2 Special design
03/2007 Edition
32
2
: When you push it in, make sure that the pins of the ODU connector are not bent. Once you
have installed the table successfully, check that the table and the ODU connector are seated
correctly.
2
: Plug in the cable at connector X121 (03002492-01) and run it through the cable duct and into
the body of the machine.
2
ODU connector
Cable for table
communication