Schneller MTC Wechseltisch - 第43页
Special design Assembly instructions Changeover table in place of the MTC2 03/2007 Edition 43 : Click on “Y es” to unin stall the software. 2 2 : The following windows appear while the uninstalling, wait until the final …
Assembly instructions Changeover table in place of the MTC2 Special design
03/2007 Edition
42
: To make sure the registration information is correct, you are asked again. If it is correct, click
on “Yes” if not click on “No” and insert it correctly.
2
2
: Choose “Uninstall SOKO” and click on “Next” to continue.
2
Special design Assembly instructions Changeover table in place of the MTC2
03/2007 Edition
43
: Click on “Yes” to uninstall the software.
2
2
: The following windows appear while the uninstalling, wait until the final screen appears which
says that the uninstalling was completed successfully.
Click “Finish” and restart the machine afterwards to activate the new settings.
2
2
2
Assembly instructions Changeover table in place of the MTC2 Special design
03/2007 Edition
44
2
2.10 Calibration
The table can be calibrated using the iron-type gauge in SITEST. 2
Feeder position detection is also possible. 2
2.11 Job changes in SIPLACE Pro
The following procedure is recommended: 2
: Stopp the old job.
: Remove the MTC/changeover table.
: Install the changeover table/MTC.
: Start the new job.
2
2
It can come to troubles in the CAN bus system at non-observance. A restart of the placement
machine is inevitable. 2