SPS Configuration SX1 - 2-Version-4 - 第17页
13.11.2018 Page 17 Calibration and Test Smart Pin Support up to software versio n 711.1 Calibration steps: 13. Of fset Pin picker -> PCB camera 14. Posi tion check on the lifti ng table 15. Calibrate magaz ine positio…
13.11.2018 Page 16
Configuration SPS for SX2 with WPC
Location 1/2
Table position outer
Only with this configuration an
SPS magazine is required on
location 2 in combination with
stat. camera SST33!
Support plate for location 2
necessary!
Gantry 1
SST33
FCU
Sensor
Sensor
WPC
5/6
FC/3D
FCU
Sensor
Sensor
Sensor
Gantry 2
Gantry 1
SST33
FCU
Sensor
Sensor
WPC
5/6
ST33
FCU
Sensor
Sensor
WPC
5/6
FC/3D
Gantry 2
Location 1/2
Table position outer
SPS magazine Q10 on NC position 4
SST33
Pin Picker
13.11.2018 Page 17
Calibration and Test Smart Pin Support
up to software version 711.1
Calibration steps: 13. Offset Pin picker -> PCB camera
14. Position check on the lifting table
15. Calibrate magazine position
Endurance test for
SPS Head
13.11.2018 Page 18
Calibration and Test Smart Pin Support
from software version 712.0
Combined Calibration steps include all Pin Picker calibrations:
Offset Pin picker -> PCB camera
Position check on the lifting table
Calibrate magazine position
New - Endurance for SPS
Pin Picker under
Maintenance