JO-116-001_w.pdf - 第114页

4-29 JO-1 16 1 105-001 2.1 Operation Procedure for [Measurement T ype 4] (8) Perform the recognition mark position teaching. Fig. D34 (9) Perform the Lane 1 pick-up hole position teaching. Notice T each all 45 hole posit…

100%1 / 161
4-28
JO-116
1105-001
2.1 Operation Procedure for [Measurement Type 4]
(7) When the sprocket reference positioning operation is completed,
the following operation guide message is displayed.
Then, attach the master tape and light shading jig correctly.
Reference
Refer to "2.3 Attachment and Detachment of Master Tapes" in
Section 4, for the attachment of the master tape.
Set the master tape and light shading
jig and click the [OK] button.
When the attachment is completed, click the [OK] button.
After that, the same adjustment operation procedure as for [Measurement Type 3] is performed.
Recognition mark position teaching, L1, L2 pick-up holes (every 45 perforations) teaching
Fig. D33
4-29
JO-116
1105-001
2.1 Operation Procedure for [Measurement Type 4]
(8) Perform the recognition mark position teaching.
Fig. D34
(9) Perform the Lane 1 pick-up hole position teaching.
Notice
Teach all 45 hole positions as many as for one turn of the
sprocket. Do not omit any of them.
The measurement times are increased. However, it is the
operation required for the sprocket offset adjustment.
Fig. D35
4-30
JO-116
1105-001
2.1 Operation Procedure for [Measurement Type 4]
(10) Teach the Lane 2 pick-up hole teaching.
As above, teach all 45 hole positions as many as for one turn of
the sprocket.
Fig. D36
(11) When the teaching for all the pick-up holes for Lane 2 is
completed, each offset data calculation processing is started
based on the teaching results.
(The values displayed on the window are updated with a
mathematical operation).
(12) When each offset data calculation is completed, the direction Z
offset input window is displayed.
When the pick-up height data is not to be changed, press the [Cancel] button.
When the pick-up height data is to be changed, enter the offset value and press the [OK] button.
Fig. D37