00198356-01_AI_Input-Extension_SX12_DE_EN_web - 第60页
3 Installation 3.5 Mounting the hand guard belt extension Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2 Option Input Conveyor Extension 05/2017 60 3.5 Mounting the hand guard belt extension Fig.13: Adapter…
Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2
Option Input Conveyor Extension 05/2017
3 Installation
3.4 Installing the belt guide extension
59
3.4 Installing the belt guide extension
This section describes how to install the belt guide extensions on the machine:
Fig.11: Belt tensioning with belt guide extension (example shows conveyor rail A/C)
Fig.12: Toothed belts and drive
► Thread in the toothed belt (L=1653mm)
[03127522‑xx].
See also: 4.1.5 "Replacing the Toothed Belt
(Conveyor Belt)" [}68].
► Mount the belt guide extension on the conveyor
(torque 6 Nm).
See also: 4.1.4 "Replacing the clamping rail and
belt guide" [}66].
► Mount the drive (torque 1.7 Nm).
See also: 4.1.2 "Replacing the Tape Drive
[03092315-xx]" [}64].
► Mount the hexagonal shaft.
See also: 4.1.1 "Replacing the Hexagonal Shaft
[03094006-xx]" [}63].
► Repeat these steps for all conveyor rails.
3 Installation
3.5 Mounting the hand guard belt extension
Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2
Option Input Conveyor Extension 05/2017
60
3.5 Mounting the hand guard belt extension
Fig.13: Adapter plate
► Use four screws (2) [03042572‑xx] to fasten the
adapter plate (1) [03121015‑xx] to the input side
of the machine.
Fig.14: Removing the top cover
► Remove both screws(1) that fasten the top
cover.
ð You can now flip open the top cover. This sim-
plifies installing the hand guard belt extension.
Fig.15: Mounting the hand guard belt extension
► Lift the hand guard belt extension (1)
[03119279‑xx] to the machine. Use an appropri-
ate tool if necessary (e.g. a crane).
Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2
Option Input Conveyor Extension 05/2017
3 Installation
3.5 Mounting the hand guard belt extension
61
Fig.16: Adapter plate
► Hook the hand guard belt extension
[03100054‑xx] onto the six threaded pins (2) of
the adapter plate (1).
Fig.17: Mounting the hand guard belt extension
► Use six self-locking M6-8 [03010700‑xx] nuts (1)
to fasten the hand guard belt extension.
Fig.18: Fastening the top cover
► Fix the top cover with two fastening screws(1).
This is necessary to prevent someone from reaching
into the running machine.