4OM-1011-002 - 第17页
Tg0860-PM-MM 2. Preparation for Maintenance 2.1 Preparation for Cleaning Prepare the cleaning tools. • Brush Use a brush whose bristles do not come off easily . • Rag Use a rag (such as cotton) which produces as little w…
Tg0860-PM-MM
Power Breaker
Padlock (No. 2500 30mm)
1. Precautionary Items before Maintenance
0307-002 1-1
1. Precautionary Items before Maintenance
This session describes how to perform inspections, cleaning, lubrication, and
adjustment to keep the machine in good shape.
It is recommended that periodic maintenance of the machine should be en-
sured.
• Only qualified personnel should perform maintenance work carefully in
compliance with the specified procedures.
WARNING
Fig. 4A1
Fig. 4A2
• Before maintenance work, be sure to lock the power breaker
and the main valve section (air source) with padlocks.
Power Breaker : Set the power breaker to the “OFF” side and
lock it with a padlock.
Air Source : Set the main valve in the direction shown in the
figure and lock it with a padlock.
• Designate a person who can have charge of the padlock key.
• If the provided padlock is lost or damaged, purchase its sub-
stitute.
Power Supply Section
Air Source Section
WARNING
Padlock
(No. 2500 25mm)
Main Valve
Tg0860-PM-MM
2. Preparation for Maintenance
2.1 Preparation for Cleaning
Prepare the cleaning tools.
• Brush
Use a brush whose bristles do not come off easily.
• Rag
Use a rag (such as cotton) which produces as little waste thread as possible.
A clean rag should also be prepared, depending on the spots to be cleaned.
• Oiled Rag
Use a rag (such as cotton) which produces as little waste thread as possible,
dampened with grease which is used for lubrication.
Note: Do not apply too much oil to the rag.
The oil should not be mixed with another type.
• Air Gun
Use the one on the market.
• Vacuum Cleaner
Use the one on the market.
Ref.: If the end of the suction mouth is narrowed, some spots can be cleaned
more easily.
• Air Blow for Camera
Use the one on the market.
• Vacuum Filter Replacement Jig
Use the standard accessory parts.
• Container, etc.
Use a container of such capacity that the water does not overflow when the
drain is cleaned.
2.2 Preparation for Lubrication
Prepare the specified grease and lubricating tools.
• The specified grease
(1) Refer to “Grease”.
• The specified lubricating tools
(2) Brush (3) Vinyl gloves (4) Grease applicator (5) Hand grease gun
Refer to “KH120”
(1) Grease
• DAPHNE EPONEX GREASE No.1
• NEW MOLYNOC GREASE No.1
• SILICONE GREASE KS64
2. Preparation for Maintenance
0305-001 1-2
Tg0860-PM-MM0305-001 1-3
2.2 Preparation for Lubrication
Same Types of Lubricants
Equivalent for DAPHNE EPONEX GREASE No.1 (IDEMITSU KOSAN CO.,
LTD.)
Equivalent for NEW MOLYNOC GREASE No.1 (Nippon Oil Corporation)
Equivalent for SILICONE GREASE KS64 (SHIN-ETSU CHEMICAL CO.)
(2) Brush
Use a brush whose bristles do not come off easily.
(3) Application by Hand
Use a pair of vinyl gloves to apply grease by hand.
(4) Grease Applicator
Use a normal grease applicator on the market.
Table 4A2
Table 4A1
Table 4A3