DEK INFINITY USER MANUAL - 第306页
INFINITY &21680$ %/(5(3/ (1,6+0(1 76 %/8(81'(5 6&5(( 1&/($1 (5 9.22 User Manual Software Versi on 7 Paper Re plenis hment W ARNIN G PROTECTI VE CLOTHING . APPROV ED PROTECTI VE CLOTHING SH OULD BE WOR…
INFINITY
&21680$%/(5(3/(1,6+0(176
%/8(81'(56&5((1&/($1(5
Software Version 7 User Manual 9.21
1. Remove the solvent tank cap (1) from the solvent tank (2).
2. Using a suitable container refill the tank and replace the cap.
3. Press Prime Solvent (F6). The message ‘Press the two button control
buttons to prime solvent.’ is displayed.
4. Prime the solvent using the two button control.
5. Press Lower Head (F2).
6. Remove the head prop.
7. Select Confirm (F1).
8. Lower the printhead using two button control.
9. Close the printhead cover.
10.Press the System button.
1
2
Lower
Head
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
Lower
Head
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
Confirm Cancel
INFINITY
&21680$%/(5(3/(1,6+0(176
%/8(81'(56&5((1&/($1(5
9.22 User Manual Software Version 7
Paper Replenishment
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHING SHOULD BE
WORN BY SOLDER PASTE AND SOLVENT HANDLERS AT ALL TIMES TO
ELIMINATE FUME INHALATION, EYE CONTACT, SKIN CONTACT AND
INGESTION.
WARNING
FLAMMABLE. THE USED PAPER ROLL CONTAINS RESIDUES OF
UNDERSCREEN CLEANER FLUID AND SOLDER PASTE. OBSERVE
MANUFACTURERS’ RECOMMENDED DISPOSAL INSTRUCTIONS.
NOTE
When using 300 or 400mm wide paper rolls, ensure the correct paper roll
spacers are used.
1. Lift the empty roll from the front of the cleaner.
2. Remove the paper spindles from both ends of the empty paper roll.
INFINITY
&21680$%/(5(3/(1,6+0(176
%/8(81'(56&5((1&/($1(5
Software Version 7 User Manual 9.23
3. Remove the take up roll from the rear of the unit by easing the roll to the left
against spring pressure, until the right hand end is clear of the motor drive
spindle in the right hand end plate. Lift the take up roll clear of the unit.
4. Rotate the left hand flange a quarter turn to the right to unlock the paper roll
rod from the paper roll shaft.
5. Rotate the paper roll end flange a quarter turn to the left and right, whilst
gently pulling the rod clear of the paper roll.