222085 Issue 1 - Horizon APiX Appendix Manual - 第82页
TECHNICAL REFERENCE APPENDIX CALIBRATIONS Chapter Issue 1 June 15 Appendix to Micron Technical Manuals 3.45 13. Using a ta chometer fitted with the surface speed te st wheel, positioned on the input or output pulley of t…
TECHNICAL REFERENCE APPENDIX
CALIBRATIONS
3.44 Appendix to Micron Technical Manuals Chapter Issue 1 June 15
10. Using a tachometer fitted with the surface speed test wheel, positioned on
the input or output pulley of the front belt motor, measure the speed of the
motor right to left.
NOTE
For heavy board option the ‘Front’ settings refer to the rear rail and the ‘Rear’
settings refer to the front rail.
11. Ensure that one of the following speeds is achieved:
a. 29 to 31 m/min for standard transport rails.
b. 37 to 39 m/min for heavy board transport rails.
c. Repeat steps 10 and 11 a for Front R 2 L, Rear L 2 R, and Rear R 2 L.
12. In the table highlight Front L 2 R ALT Speed.
Rear Belt Speed using Digital Tachometer
Surface Speed Test Wheel
TECHNICAL REFERENCE APPENDIX
CALIBRATIONS
Chapter Issue 1 June 15 Appendix to Micron Technical Manuals 3.45
13. Using a tachometer fitted with the surface speed test wheel, positioned on
the input or output pulley of the front belt motor, measure the speed of the
motor right to left.
NOTE
For heavy board option the ‘Front’ settings refer to the rear rail and the ‘Rear’
settings refer to the front rail.
14. Select Incr. or Decr. to adjust the motor speed to achieve 14 to 16 m/min.
15. Repeat steps 13 and 14 for Front R 2 L Alt Speed, Rear L 2 R Alt Speed,
and Rear R 2 L Alt Speed.
16. If adjustment is required, remove the belt speed adjuster cap on the appro-
priate motor and adjust using a suitable trimming tool.
17. Select Next.
Rear Belt Speed using Digital Tachometer
Surface Speed Test Wheel
Belt Speed Adjuster Cap
View on Front Rail Transport Belt Drive Motor
TECHNICAL REFERENCE APPENDIX
CALIBRATIONS
3.46 Appendix to Micron Technical Manuals Chapter Issue 1 June 15
18. Select Incr. or Decr. to start the belts running left to right.
19. Ensure that one of the following speeds is achieved for both the front and
rear belts:
a. 29 to 31 metres/min for standard transport rails.
b. 37 to 39 metres/min for heavy board transport rails.
NOTE
There is no separate adjustment between left to right and right to left. If the
above speed is not achievable in both directions, the motor may be faulty.
20. Select Exit.
21. Select Exit.
22. Select Back.
23. Refit the safety cover.