00196577-03 JG S-Feeder Care Test Station EN - 第23页
Performing the Test – Switching Tracks 23 – S w it c h in g T r a c k s Check all the tra cks to b e t ested, to make sure that the t ooth is always in the cen ter of the image. To switch over tracks while the live image…
Performing the Test – Checking the Pickup Position
22
– Checking the Pickup Position
Top
The pickup position has been set correctly. The tooth is in
the center and can be easily recognized for measurement
by the camera.
Bottom
The space between the teeth can be seen. The camera is
not able to recognize the tooth. If the automatic test is start-
ed with this setting, you will see an error message and the
test will be terminated.
► Manually adjust the pickup position on the feeder to be
tested so that the tooth is positioned in the center, as
shown in the top image.
Performing the Test – Switching Tracks
23
– Switching Tracks
Check all the tracks to be tested, to make sure that the tooth
is always in the center of the image.
To switch over tracks while the live image is shown, use the
Options list.
L = Left track
M = Middle track
R = Right track
Performing the Test – Switching off the Live Image
24
– Switching off the Live Image
The live image can be switched off with the Live Image Tape
Position Off (F7) button. You will see the normal view again,
in which all buttons are active.
► Click on the Live Image Tape Position Off (F7) button or
press the F7 key.
TIP: To view all measuring points, click again on the select-
ed feeder type in the selection list at the top left.