SPS Configuration SX1 - 2-Version-2 - 第10页

20.04.2017 Page 10 Conf i gur at i on SPS f or SX2/ SX1 T o reduce the di versi ty of conf i gurati ons of the SPS m agazines, the foll ow i ng variants have been be defined: 1. For the SX 1 i t i s not possi bl e to con…

20.04.2017 Page 9

Configuration Smart Pin Support (SPS) on SX1/2

The SPS unit is mounted on the left side of the head holder.

User Manual SPS: 00197001-xx

Assembly Instruction SPS SX1/2: 00197002-xx

20.04.2017 Page 10

Configuration SPS for SX2/SX1

To reduce the diversity of configurations of the SPS magazines, the following variants

have been be defined:

1. For the SX1 it is not possible to configure an SPS magazine on location 2, whether if

there a single- or dual conveyor.

2. For the SX2, only the SPS magazine Q10 on location 2 will be supported if a WPC

with two stationary cameras or 3D-coplan is mounted on location 1. The support

plate for location 2 is necessary.

3. The IC - Camera is not a precondition to use the Q10 magazine, but if no

IC camera installed, the Support plate 1 for location 1 is necessary.

20.04.2017 Page 11

Configuration SPS for SX1

Gantry 1

Sensor

FCU

Sensor

Sensor Sensor

Sensor

Gantry 1

Sensor

FCU

Sensor

Gantry 1

FCU

Sensor

FC/3D

SST33

Location 1/2

Table position inner

SPS magazine L10 on

NC position 2

Location 1

Table position outer

SPS magazine L10 on

NC position 2 and/or L10

on NC position 3

Location 1

Table position outer

SPS magazine L10 on

NC position 2