D-serie LEVEL II - 第165页
Component Handling Empty Tape Duct Room for Your Sketches and Notes S tude nt Guide Advanced Level 2 SIPLACE D Series EN 05/2007 Component Handl ing 9-15 9.5 Room for Y our Sketches and Notes
Component Handling
Pneumatic Tape Cutter Function Test for Tape Cutter in the Machine
Student Guide Advanced Level 2 SIPLACE D Series
Component Handling EN 05/2007
9-14
9.4.3 Function Test for Tape Cutter in the Machine
Since the noise of the tape cutter does not indicate whether the cutting procedure is being performed
correctly, the function of the tape cutter can only be checked by inserting a piece of paper with the
relevant length into the cutting channel.
X To prepare the test, use an adhesive strip to attach a sheet of DIN A4 paper lengthwise into the
empty tape duct.
X Now start the SITEST menu Component Table and activate the option "Actuate tape cutter".
X You can then examine the cutting quality on the sheet of paper.
9.4.4 Jumper Setting on the Tape Cutter Control Unit
9.4.5 Empty Tape Duct
The empty tape duct acts as a base for further modules:
The removable nozzle reject container (3)
The installation surface (5) for the C&P nozzle changer
The nozzle stripping unit (4)
NOTE:
For jumper setting details, refer to the service manual for the respective machine.
9-11: Empty-tape duct with component reject container (D4 shown as
example)
Legend
1. Inlet slot for empty tape
2. Outlet slot for the empty tape above the
pneumatic tape cutter
3. Nozzle reject container
4. Nozzle reject station
5. assembly surface for the nozzle changer
The empty tape duct receives empty tapes from
the feeders at the inlet gap (1) and guides these
from the outlet gap (2) to the cutting position of the
pneumatic cutter. This is where the tape is cut up
and falls down the waste slide, into the component
trolley waste tape container.
The empty tape duct is fixed to the pneumatic tape
cutter with four screws.
Component Handling
Empty Tape Duct Room for Your Sketches and Notes
Student Guide Advanced Level 2 SIPLACE D Series
EN 05/2007 Component Handling
9-15
9.5 Room for Your Sketches and Notes
Component Handling
Room for Your Sketches and Notes Empty Tape Duct
Student Guide Advanced Level 2 SIPLACE D Series
Component Handling EN 05/2007
9-16