D-serie LEVEL II - 第225页
SITEST New Functions in SITEST Room for Your Sketches and Notes S tude nt Guide Advanced Level 2 SIPLACE D Series EN 05/2007 SITEST 12-25 12.4 Room for Y our Sketches and Notes
SITEST
Calibration Steps and Individual Calibration Functions New Functions in SITEST
Student Guide Advanced Level 2 SIPLACE D Series
SITEST EN 05/2007
12-24
The gantry moves the TWIN
module above the
component (IC) camera.
Within a +/-5° tolerance, the
SW determines the angle
correction.
Save in Achs_ver.ma.
Calibration menus reserved for SIEMENS Service
FCCS for digital cameras White adjustment of
hardware required.
The PCB camera calibrates
the calibration tool carrier
position after this carrier
has been moved into the
PCB conveyor and clamped
into place.
Other PCB camera test
measurements follow.
All cameras programmed in
the Config.ma file are
brightness calibrated via a
whiteness adjustment
measurement.
Save in camera EPROM! The results can be saved in
the calibration value XML file.
Checking the star mounting
position in the magnetic
neutral position
The star mounting position
is checked by comparing
the magnetic neutral
position with the 'zero
position of segment 1'.
A deviation of up to 95x 1/
1000° is tolerated by the SW.
Should errors occur,
remount the placement star
on the star motor shaft.
Calibration step/
individual calibration
function
For D4 For D3 For D2 For D1 Comments
SITEST
New Functions in SITEST Room for Your Sketches and Notes
Student Guide Advanced Level 2 SIPLACE D Series
EN 05/2007 SITEST
12-25
12.4 Room for Your Sketches and Notes
SITEST
Room for Your Sketches and Notes New Functions in SITEST
Student Guide Advanced Level 2 SIPLACE D Series
SITEST EN 05/2007
12-26