JO-109-002_JG-0209.pdf - 第29页
1-1 JO-109 1. Outline This adjusting jig can be used to measure the jig origin and write the offset data in the memory of the feeder in order to maintain the accuracy and reliability of the feeder . 2. Specications T ab…
1-B
JO-109
1005-001
1-1
JO-109
1. Outline
This adjusting jig can be used to measure the jig origin and write the offset
data in the memory of the feeder in order to maintain the accuracy and
reliability of the feeder.
2. Specications
Table A1-1
Item Description
1. Model JG-0209
2. Function This jig makes it possible to perform the following measurements and write the
offset data.
Measurement of Component Pickup Position and Writing of Offset Data
for Tape Feeders
•
Lane Origin Offset
(Lanes #1 and #2 for 8 mm Tame Feeder)
•
Offset Data X, Y and Z
Notes
: (a) The master tape is required for the measurement of the X/Y
data.
(b) The following apparatuses are required for the measurement
of the Z data. These apparatuses are not included is this
feeder adjusting jig.
These apparatuses should be prepared in your company.
•
Block Gauge (104.0 mm)
•
Pry-Type Dial Gauge (0.01 mm)
•
Stand (used for the pry-type dial gauge)
•
Surface Plate (300 mm
×
300 mm or more)
•
Sprocket Offset
1. Outline
1106-002
1-2
JO-109
2. Specications
1106-002
Table A1-2
Item Description
3. Construction of
Device
•
Software for Data Writing
: Feeder Project Tester
•
Pickup Position Camera
•
Pickup Position Camera Control Unit (Power Supply for LED Illumination)
: Analog Power Supply PSB-1012V WW
•
Micrometer
•
Micrometer Unit (Measured Data Transfer Unit)
: Multiplexer MUX-10F
•
Electrical Box
: 100 V or 200 V for Exclusive Use
•
Measuring Jig
<Following provided by client>
• Personal Computer for Data Writing
• Liquid Crystal Display