JO-109-002_JG-0209.pdf - 第38页
2-2 JO-109 1.1 Procedures for Attachment of Camera Unit and Detachment of Fixtures 1005-001 1.1 Procedures for Attachment of Camera Unit and Detachment of Fixtures 1.1.1 Required T ools • Hex-Head W renches for M3 and M4…
2-1
JO-109
1. Procedure for Jig Installation
CAUTION
At least two people are needed to carry the feeder
adjusting jig for the installation because it is very
heavy.
Be sure not to drop it. Otherwise, your hands and/or
feet will get hurt or the jig may be damaged.
Fig. B1 Jig Installation
1. Procedure for Jig Installation
1005-001
2-2
JO-109
1.1 Procedures for Attachment of Camera Unit and Detachment of Fixtures
1005-001
1.1 Procedures for Attachment of Camera Unit and
Detachment of Fixtures
1.1.1 Required Tools
•
Hex-Head Wrenches for M3 and M4
•
Cutting Nipper
1.1.2 Procedure for Attachment of Camera Unit
Procedure
(1) Place the camera unit on the X/Y stage of the jig body and
temporarily x it on the X/Y stage with four bolts (SW + FW)
having M4L20 hexagonal recessed sockets (accessory parts).
Note
Before assembling it on the X/Y stage, make sure that there is
no dust and dirt on the mounting surface.
4-M4L20 (SW + FW)
Temporary Fixing
Fig. B2
2-3
JO-109
1.1 Procedures for Attachment of Camera Unit and Detachment of Fixtures
1005-001
(2) Push the side face of the camera assembly against the pilot pin on
the X/Y stage and the pilot pin on the camera assembly bottom
against the side face of the X/Y stage for rm mounting.
Push the side face of
the camera assembly
against the pilot pin
on the X/Y stage.
Push the pilot pin of
the camera assembly
bottom against the
side face of the X/Y
stage.
Fig. B3
(3) After positioning, rmly tighten the four nuts (M4L20).
Tightening Torque: 3.00 to 3.66 N
•
m (30.6 to 37.4 kgf•cm)
Note
After tightening the nuts, make sure that there is no clearance
between the pin and the pushed (mating) surface.
When a clearance is left, follow the above-described steps
again, starting with Step (2).
Firm Tightening of
Four Nuts (M4L20)
Fig. B4