Process Lens PL Service Manual_EN - 第61页

3 Replacing spare parts Se rv ic e Ma nu al P ro ce ss L en s PL - 0 3/ 20 25 61 Fig.77: Plate guides ► Remove the relevant plate guide (1) . Installation ► Press in the two pins at the plate guide. Consider the right …

100%1 / 168
3 Replacing spare parts
60 Service Manual Process Lens PL - 03/2025
Equipment and tools
00376503-xx Torx L-Wrench Set with Spherical head (Torx 30)
Overview
Fig.75: Plate guide
1. Plate guide 1
2. Plate guide 2
3. Pins
4. Self-cutting screw
Fig.76: Pins on the plate guides
1. Plate guide 1
2. Plate guide 2
TTransport direction
Removal
► Use the software or manually move the conveyor rail into a position which allows you best
access.
To move the conveyor side wall manually, pull the toothed belt of the width adjustment unit.
► Switch off the machine, disconnect it from the power supply and secure it to prevent unauthorized
reactivation.
► Dismantle the lifting table plate (see 3.5.1.2.1 "Replacing the lifting table plate" [}58]).
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 61
Fig.77: Plate guides
► Remove the relevant plate guide(1).
Installation
► Press in the two pins at the plate guide. Consider the right position depending on the position in
the lifting table. The pins are always on the outside position of the table.
► Insert the self-cutting screw in the center. You can precut the hole with this screw.
► Follow the removal instructions in reverse order for further installation. Also observe the following
instructions:
CAUTION
Installation instructions
► Place the lifting table plate onto the guidance pins. Make sure that the fastening screws slide
properly into the precut thread.
► Check the free movement of the lifting table (see Checking free movement of lifting table).
Replacing the lifting table motor
Parts
Fig.78: Lifting Table Motor
03088241-xx BLDC motor BG65x50 complete with cable and plug
3 Replacing spare parts
62 Service Manual Process Lens PL - 03/2025
Equipment and tools
00353832-xx Allen key set
00096290-xx Fork wrench set
00376503-xx Torx L-Wrench Set with Spherical head (Torx 30)
Side cutter
Cable tie
Overview
Fig.79: Lifting table motor - overview
1. Lifting Table Motor
2. Lifting table motor cable (connection to
TSP420)
3. TSP420 (under the cover)
4. Retaining bracket for the lifting table motor
Removal
CAUTION
Washers
There are washers at various points, for example between the lifting table motor and the rods.
► Make a note of the number of washers and their positions. These will need to be fitted again in
the same places later on.
► Use the software or manually move the conveyor rail into a position which allows you best
access.
To move the conveyor side wall manually, pull the toothed belt of the width adjustment unit.
► Switch off the machine, disconnect it from the power supply and secure it to prevent unauthorized
reactivation.
Fig.80: Lifting table motor
► Dismantle the lifting table plate.
3.5.1.2.1 "Replacing the lifting table plate"
[}58]
► Remove the screw(1) fastening the
rods(2). Carefully dismount the rods.