Process Lens PL Service Manual_EN - 第84页
3 Replacing spare parts 84 Se rv ic e Ma nu al P ro ce ss L en s PL - 0 3/ 20 25 Fig.110: Attaching the adhesive tapes ► Attach the adhesive tapes to the side sheet metal plates as described in the figure. Observe the f…
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 83
Equipment and tools
00326015‑xx Belt tension measuring device
00353832-xx Allen key set
03082092-xx Lint-free cleaning cloths
Ethanol
Isopropanol – IPA can be used as an alternative.
Removal
CAUTION
Do not loosen the wrong screws
Make sure that you do not loosen any other screws except those ones explicitly mentioned. Loosen-
ing other screws could lead to irreparable misalignment or damage to the conveyor.
► Use the software or manually move the conveyor rail into a position which allows you best
access.
To move the conveyor side wall manually, pull the toothed belt of the width adjustment unit.
► Switch off the machine, disconnect it from the power supply and secure it to prevent unauthorized
reactivation.
► Remove the relevant toothed belt.
Replacing the toothed belt (conveyor belt)
► Pull the old side sheet metal plate off the conveyor rail.
Installation
► Clean the adhesive surfaces on the conveyor rail.
3 Replacing spare parts
84 Service Manual Process Lens PL - 03/2025
Fig.110: Attaching the adhesive tapes
► Attach the adhesive tapes to the side sheet metal plates as described in the figure. Observe the
following points:
●
In the input area(1) towards the outside of the machine, electrically conductive adhesive tape
3M-9469 [03154790-xx] is applied on a 91mm wide stripe.
●
In the placement area(2), the electrically conductive adhesive tape is not used.
●
In the output area(3) towards the outside of the machine, a 54mm wide stripe is applied with
electrically conductive adhesive tape 3M-9469 [03154790-xx].
●
The other surfaces of the sheet metal plates are not applied with electrically conductive tape
3M-9713 [03154789‑xx]. Make sure to keep the holes for the light barriers free.
3 Replacing spare parts
Service Manual Process Lens PL - 03/2025 85
Fig.111: Input side(1) and output side(2)
► Glue the sheet metal plate to the conveyor rail. Observe the following points:
●
On the input side(1), the side metal sheet plate is attached 1mm towards the inside.
●
On the output side(2), the side metal sheet plate protrudes the rail by 2mm.
► Fit the toothed belt.
Replacing the toothed belt (conveyor belt)