00197463-03_SM_CPP_Customer_EN - 第38页

5 Front plate, star, Z axis and smoothed distributor disc 5.1 Replacing the front plate [03061102-xx] 38 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 Fig.41: Removing the cable ► Carefully release the cable (…

100%1 / 120
5 Front plate, star, Z axis and smoothed distributor disc
5.1 Replacing the front plate [03061102-xx]
Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 37
Fig.38: Version with screw
Fig.39: Version without screw
► Version with screw: Remove the screw (1)
fastening the cable.
► Version without screw: Press the cable out of
the clamp.
Fig.40: Removing the cable ties
Version with screw only:
► Cut the cable tie(1) (if present).
5 Front plate, star, Z axis and smoothed distributor disc
5.1 Replacing the front plate [03061102-xx]
38 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
Fig.41: Removing the cable
► Carefully release the cable(1) from its holder.
Fig.42: Unscrewing the ground connection for the screwed joint
► Remove the screw fastening the ground connec-
tion(1).
Fig.43: Removing the front plate
► Remove the fourscrews(1) fastening the front
plate and remove the front plate.
5 Front plate, star, Z axis and smoothed distributor disc
5.1 Replacing the front plate [03061102-xx]
Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 39
Installation
► Remove the pressure control valve from the old and fit in the new front plate.
7.1 "Replacing the PRV [03072785‑xx]" [}79]
Fig.44: Fitting the calibration nozzles
► Attach a calibration nozzle (type 2057)(1) on
each DP drive(2).
Fig.45: Inserting the DP clamping ring
Threading the driver bearings at the DP drives into the
raceway:
► Thread one half of the DP clamping ring(1) diag-
onally under the star and through.
► Thread the other half of the DP clamping ring(2)
in at the other end of the star.
► Spread both parts of the DP clamping ring(1+2)
over the type 2057 nozzles.
 NOTICE!
Make sure that the two turnbuckles(3) are at
the side of the head.
.
► Close the two turnbuckles one all nozzles have
been properly threaded in.