00197463-03_SM_CPP_Customer_EN - 第52页

5 Front plate, star, Z axis and smoothed distributor disc 5.4 Removing the valve terminal (only for heads from FS05 upwards) 52 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 Fig.75: Fastening the valve terminal…

5 Front plate, star, Z axis and smoothed distributor disc

5.4 Removing the valve terminal (only for heads from FS05 upwards)

Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 51

Installation

Fig.72: Checking the seal

► Check the position of the seal.

Fig.73: Checking the ball bearings

► Check the ball bearings.

These ball bearings may not protrude above the

surface.

 NOTICE!

If the ball bearings are defective, you will

need to replace the valve terminal.

Fig.74: Inserting the valve terminal

► Place the valve terminal on the star carrier.

Pay attention to the correct position of the pins

and to the position of the Flexprint cable.

5 Front plate, star, Z axis and smoothed distributor disc

5.4 Removing the valve terminal (only for heads from FS05 upwards)

52 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018

Fig.75: Fastening the valve terminal

1. The old valve terminal [03082217‑xx] is fixed with

six screws to the heads up to and including

FS04.

2. The new valve terminal [03115167‑xx] is fixed

with five screws to the heads up to number [KL-

J5-0162] .

3. The new valve terminal [03115167‑xx] is fixed

with six screws to heads from number [KL-

J5-0162].

► Fasten the valve terminal with the screws

provided.

Tighten the screws crosswise with a torque of

0.17 +/- 0.03Nm.

Fig.76: Flexprint cable

1. Connector closed

2. Connector open

3. Flexprint removed

► Insert the Flexprint cable as far as the stop into

the connector and lock the connector.

► Follow the removal instructions in reverse order for further installation.

Also observe the installation instructions in the following sections:

5.6 "Replacing the energy transmission for the rotor [03068843‑xx]" [}63]

5.2 "Removing and fitting the star (only for heads from FS05 upwards)" [}43]

5.1 "Replacing the front plate [03061102-xx]" [}35]

► Observe in particular the torques specified!

5 Front plate, star, Z axis and smoothed distributor disc

5.5 Replacing the Single Core Solution (SCS)[03054790Sxx] (only for heads fromFS05)

Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 53

5.5 Replacing the Single Core Solution (SCS)[03054790Sxx]

(only for heads fromFS05)

Parts, equipment and tools

●

SCS assembly CPP [03054790Sxx]

Overview

Fig.77: Star structure

1. Energy transmission for rotor

2. Valve terminal

3. Star carrier with DP drives

4. Single Core Solution (SCS).

5. Holding circuit with screwed joint

Fig.78: SCS

The SCS consists of two boards, the power and the

control module.