80S-2080F480F5 - 第599页
SIPLACE 80 S20/F4/F5 User Manual 10 Component Handling 05/99 Issue from Software Vers ion SR.405.xx 10.6 Wafflepack Changer 10 - 27 Undo the clamp ing screws at the fee t (see Fig. 10.6.5 ) and using a 10 mm ba ll sock e…
10 Component Handling SIPLACE 80 S20/F4/F5 User Manual
10.6 Wafflepack Changer 05/99 Issue from Software Version SR.405.xx
10 - 26
10.6.9 Fitting the Wafflepack Changer
Before moving the WPC into the machine, remove the upper part of the camera of the component vision
module.
NOTE
The wafflepack changer can be moved into and out of the machine on its wheels, but it should be noted that
these wheels are not suitable for moving the wafflepack changer over longer distances. DANGER OF OVER-
TURNING! In such cases use the suitable lift truck (from item no. 00123141-01).
Move the wafflepack changer carefully into the desired location in the machine.The docking pins of the
wafflepack changer must be located above the docking slots of the SIPLACE machine.
Check the dimension (87 ± 0.5 mm) between lower edge of tray and top of component table (see Fig.
10.6.5).
Fig. 10.6.5 Aligning the wafflepack changer
-Key to Fig. 10.6.5
1 With socket wrench UP/DOWN 2 Clamping screw
3 Stroke 4 Docking pin
5 Upper edge of the magnetic bar of the component table 6 Lower edge of tray
7 Nominal stroke (459 mm) 8 Refill position (470 mm)
SIPLACE 80 S20/F4/F5 User Manual 10 Component Handling
05/99 Issue from Software Version SR.405.xx 10.6 Wafflepack Changer
10 - 27
Undo the clamping screws at the feet (see Fig. 10.6.5) and using a 10 mm ball socket wrench rotate the
wafflepack changer downwards until the docking pin engages. The wafflepack changer must at this point
be aligned using the machine spirit level fitted to the wafflepack changer.
Tighten up the clamping screws and check the machine spirit level again.
Reinstall the upper part of the camera on the component vision module.
10.6.10 Technical Data
Wafflepack changer
Length approx. 1475 mm
Width approx. 620 mm
Height approx. 1355 mm
Weight approx. 240 kg
Magazine size 238 mm x 338 mm
Vertical stroke 470 mm
Horizontal stroke 730 mm
Pitch 17 mm
Storage unit capacity 28 trays for holding flatpack magazines
Tray 260 mm x 360 mm
Max. weight of storage unit 50 kg
Floor load < 25N/cm²
Changeover time (magazine/magazine) ≤ 3 sec.
Tab. 10.6.1
10 Component Handling SIPLACE 80 S20/F4/F5 User Manual
10.6 Wafflepack Changer 05/99 Issue from Software Version SR.405.xx
10 - 28