00196613-0102_AI_LP-Dicke6mmDE EN - 第24页
2 Assembly instructions: 6 mm PCB thickness SIPLACE SX1 / SX2 6 mm PCB thickness 06/2009 Edition 24 : Fit all the clamping bars and stopp ers. 2 As you tighten the bolt s, push the conveyor rails outwards (against the co…
6 mm PCB thickness 2 Assembly instructions: 6 mm PCB thickness SIPLACE SX1 / SX2
06/2009 Edition
23
: Make sure that the rails are aligned with the outside of the conveyor rail. To do this, insert the
clamping rail so that the PCB clamping edge is pointing up..
2
2
: Remove all the stoppers and insert the 29 mm spacer bar.
Insert the plates beneath each stopper (3 on each conveyor rail).
2
Bars for spacing
Clamping rails with spacing bars inserted
Plates
2 Assembly instructions: 6 mm PCB thickness SIPLACE SX1 / SX2 6 mm PCB thickness
06/2009 Edition
24
: Fit all the clamping bars and stoppers.
2
As you tighten the bolts, push the conveyor rails outwards (against the contact edge). 2
2
2
: Measure the height of the conveyor again at at least 4 points as shown in the picture on page
19. It must measure 176.8 +/-0.2 mm once more.
2
The height must be exactly as stated, otherwise there is a risk of crashing. 2
2
2
: If you have not done so already, you should now fit the optional stopper. You will find the details
in the Assembly Instructions: Optional Stopper SIPLACE SX1/SX2 (item no.: 00196449-xx).
2
2