3OM-1343-008_w.pdf - 第106页

3-21 AKFEDT -ID local Select one of the following options to determine whether or not the ﬁdu cial mark on each component p lacement point sho uld be recognized . Disable : The local recognition function is not used. Ena…

3-20

AKFEDT-ID

Image

When "Enable" is selected, set one of the following options as an image

recognition mode.

Disable :

The image recognition function is not used.

Enable :

The image recognition function is used.

Fiducial Marks

Unit PCB (Multi-Unit PCB)

Fig. 3C20

Note

When the global recognition function is used together with the image

recognition function, both recognizing actions take place but the placement

coordinates are corrected according to the result of the image recognition.

0601-002

1.2 Operation Data

3-21

AKFEDT-ID

local

Select one of the following options to determine whether or not the

ﬁdu

cial mark on each component placement point should be recognized.

Disable :

The local recognition function is not used.

Enable :

The local recognition function is used.

Note

(a) When "Enable" is set in the text box, the deviation of each component

placement point can be corrected.

(b) A component placement point and each recognition mode can be

speciﬁed in "(D02_09)

V" of the placement data (P-data) and the

coordinates and mark code of a ﬁducial mark can be designated in

(D02_12), (D02_13), and (D02_14) of the placement data (P-data).

1-Point Recognition :

Put a ﬁducial mark on the center of component

placement point or a desired point around the

center.

Fiducial Mark

Fig. 3C21

2-Point Recognition :

Put two points (ﬁducial marks) symmetrically

on both sides of the center of the placement

position. (A-A', B-B')

Fiducial Marks

Fig. 3C22

0611-003

1.2 Operation Data

3-22

AKFEDT-ID

(A02_04)

Fiducial mark

When "1 Point", "2 Point", or "3 Point" is selected for the global PEC

recognition mode, the coordinates and mark code of each ﬁ ducial mark

must be entered in the corresponding text boxes.

Zones 1, 2, 3, 4, and 5

#1 X [mm] (Horizontal) and Y [mm] (Vertical)

Set the coordinates of the ﬁ rst ﬁ ducial mark in the text boxes.

#1 Mark Code

Set the mark code of the ﬁ rst ﬁ ducial mark in this text box.

#2 X [mm] (Horizontal) and Y [mm] (Vertical)

Set the coordinates of the second ﬁ ducial mark in the text boxes.

#2 Mark Code

Set the mark code of the second ﬁ ducial mark in the text box.

#3 X [mm] (Horizontal) and Y [mm] (Vertical)

Set the coordinates of the third ﬁ ducial mark in the text boxes.

#3 Mark Code

Set the mark code of the third ﬁ ducial mark in the text box.

Reference

Refer to "(A03) PEC Recognition Mark Data" for the mark codes.

0601-002

1.2 Operation Data