P-277-004e.pdf - 第5页
MODEL CU-G300L/R 0712-002 CONT -1 目 次 CONTENTS Fig. DC カッタ部 DC CUTTER SECTION DC Fig. DC-1 フレーム部 Base Frame Fig. DC-2 駆動部 Driving Section Fig. DC-3 カッタ部 Cutter Section Fig. DC-4 レバー部 Lever Section Fig. DD カッタ部 DD CUTTER …
MODEL CU-G300L/R
1004-004
USING YOUR EXPLODED ILLUSTRATION
This Exploded Illustration shows the information about the parts of Cutter Unit
CU-G300 L/R for GXH-3 Series and is made for Parts Ordering.
You must not replace a part with a new one according to only the information of this
Exploded Illustration.
1. Inquiring
For identification of each part, numbers are placed on illustration pages. These
numbers (Key No.) again appear in the far left column of the part table joined up
with the illustration.
The number shown in the Q’ty column of the part table represents the quantity of
certain part used in the equipment. In case of unit assembly, however, the number
represents the quantity of certain part contained in single unit.
2. Parts Ordering
For ordering parts, some parts might not be supplied as a single item, due to the
constitution of such parts.
When ordering parts, be sure to inform us of the following details:
Model
T
ype
Serial No.
Fig. No.
Key No.
PART No.
P
AR
T NAME
Quantity
[Example]
3. Miscellaneous
This Exploded Illustration is subject to change without prior notice.
All rights reserved. No part of this work covered by the copyrights hereon may be
reproduced or copied without written permission of the publisher.
'' NOTE '' is used to show the notice that is not directly related to safety.
Some of the parts shown in the Exploded Illustration could fall into the scope of your
government’
s regulations on strategic products. In that case, anybody who intend to
export the product should acquire due authorization.
CU-G300L
Model Type
123456S 7890
Serial No.
Key No.140
Key No.
6300937039
PART No.
Q'ty
1
Fig. No.
Fig. DC-2
PART NAME
SENSOR,PROXIMITY
PREFACE-2
MODEL CU-G300L/R
0712-002
CONT-1
目 次
CONTENTS
Fig. DC
カッタ部
DC CUTTER SECTION DC
Fig. DC-1
フレーム部
Base Frame
Fig. DC-2
駆動部
Driving Section
Fig. DC-3
カッタ部
Cutter Section
Fig. DC-4
レバー部
Lever Section
Fig. DD
カッタ部
DD CUTTER SECTION DD
Fig. DD-1
ベースフレーム
Base Frame
Fig. DD-2
駆動部
Driving Section
Fig. DD-3
カッタ部
Cutter Section
Fig. DD-4
レバー部
Lever Section
MEMO