Dek-265GSX-User-Manual - 第54页
5. Fit the tooling tower to the manual tooling plate. Ensure the dowels on the front edge of the tooling tower base are correctly seated in the holes in the front edge of the manual tooling plate. 6. Verify the plate ass…
STAGE 6C
Tooling Setup - Dedicated Tooling System
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1.
Select Change Tooling (F6).
Change
Tooling
2.
Select Full Width (F5).
Full
Width
3.
Select Raise Head (F2).
Raise
Head
4. Raise the printhead using two button control. Fit the head prop.
Software Version 6 User Manual 1.37
MACHINE PROGRAMMING
STAGE 6C
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONTAND REAR BOARD CLAMPS
AREVERYSHARP.
5. Fit the tooling tower to the manual tooling plate. Ensure the dowels on the
front edge of the tooling tower base are correctly seated in the holes in the
front edge of the manual tooling plate.
6. Verify the plate assembly orientation and fit the assembly to the tooling
tower. Ensure the dowels of the plate assembly are correctly seated in the
holes in the tooling tower.
7. If required, slide the additional magnetic pins beneath the plate assembly to
fully support it when printing wide boards.
1.38 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 6C
View on Rear of Tooling Plate
8. Remove the head prop. Lower the printhead using two button control.
9.
Press the System button.
10.
Select Board Width (F5).
Board
Width
11.
Select Board Stop (F4).
The camera moves to the board stop position. The board stop on the camera
extends.
12.
Select Raise Head (F2).
Raise
Head
Software Version 6 User Manual 1.39
MACHINE PROGRAMMING
STAGE 6C